Abstract:In order to meet the increasing requirements of synchrotron radiation users, a new plan of VUV and soft X-ray light source, named Hefei Advanced Light Source (HALS), is brought forward by National Synchrotron Radiation Laboratory (NSRL). This 1.5GeV storage ring with ultra low emittance 0.2nmrad consists of 18 combined FBA cells and the circumference is 388m. Strong enough quadrupoles and sextupoles must be needed for getting such low emittance lattice, which will lead beam close orbit distortions’ (COD) sensitivity to the field and alignment errors in magnets. Estimation of the COD from various error sources is investigated. Using orbit response matrix and singular value decomposition method, the distribution of beam position monitors and the location of correctors are reported in the paper. Simulation proves that COD can be corrected down to 60 microns level. In the same time the corrector strengths are weaker enough in the correction scheme. INTRODUCTION Hefei Light Source (HLS) of National Synchrotron Radiation Laboratory is a dedicated second generation light source. In order to obtained synchrotron radiation with high brightness and better coherence in the VUV and soft X-ray range for users, A plane of building a new machine named HALS storage ring has been brought forward [1]. In the preliminary design, considering the required low emittance, the straight lines’ number and length, A FBA lattice structure with 18 super-periods has been chosen for HALS. Figure 1 shows the and dispersion functions of one cell, from which we can see there is no dispersion in straight sections. Main parameters about HALS storage ring can be founded in table1 [2]. In the design, strong quadrupoles and sextupoles have been used because of the low emittance lattice structure. The magnet alignment errors will lead to larger closed orbit distortion (COD), which can induce unwanted side effects. The non-linear effect can make the dynamic aperture and beam lifetime decreasing. Furthermore, it will change the synchrotron light’s position at the beamline front ends, which can influence the brightness at experiment station. In order to correct the COD, Beam Position Monitors (BPMs) and correctors must be installed. In the paper, COD is estimated considering alignment errors in magnets and girders. Magnets field errors are also included. Using SVD method, the closed orbit distortions are corrected. In the same time, corrector strengths and residual closed orbit distortions are obtained. Figure 1: and dispersion functions of one cell. Table 1: Main Parameters of HALS Storage Ring

Closed Orbit Correction of HLS Storage Ring

DEVELOPMENT OF ORBIT CORRECTION SYSTEM OF HLS STORAGE RING

MATLAB Based Beam Orbit Correction System of HLS Storage Ring

The Stable Orbit of the Small Satellite Flying-Around the Space Station and the Orbit Maintenance

Correction Of Closed Orbit And Dispersion Function In The Electron Storage Ring

Correction of storage ring optics with an improved closed-orbit modulation method

Closed orbit correction of hefei advanced light source (hals) storage ring*

Local bump of beam closed orbit in HLS

Closed orbit correction of hefei light source(HLS) upgrading storage ring

Electron Equilibrium Orbit Adjustment and Closed Orbit Correction in Hefei Electron Storage Ring

Design of Control for Beam Based Alignment System at HLS

Effects of Alignment Errors on the Orbit Function in HLS Storage Ring

Control System of Slow Beam Orbit Feedback on MATLAB for HLS

Beam optics correction in the PLS-II storage ring

Orbit stabilization for the new insertion devices in SSRF

Upgrade of the HLS storage ring corrector power supply control system

Measurement and Compensation of BPM Chamber Motion in HLS

Local bump of beam closed orbit in Hefei Light Source

The Correction of the Coupling in HLS

The system of slow beam orbit feedback for HLS

Ramping Control of HLS Storage Ring