Abstract:Fully developed turbulent pipe flow at Re=11300 as well as Re=5300 is measured by PIV using water as working fluid. Excellent agreement with DNS (Direct Numerical Simulation) by Satake (2000) is achieved by choosing optimum measurement parameters such as spatial resolution, time separation of two images, and number of samples. The test section is 6.7m long stainless steel pipe with transparent PIV measurement section attached seamlessly at the end. The measurement section consists of transparent acrylic circular pipe of 1mm thick and water jacket with square cross section. The water jacket reduces the image distortion due to the pipe curvature in almost entire area of the pipe cross section to negligible level except for the region very close to the pipe wall. For turbulent flow measurement using PIV, the requirement for spatial resolution is very severe in order to resolve the fluctuating velocity field especially at high Reynolds number. Therefore, higher magnification is chosen at the cost of the size of measurement area to assure enough spatial resolution. Consequently, the size of the measurement area is half of the pipe radius and measurement is performed at two regions which are called near-wall region and pipe center. For image analysis, the iterative multi-step cross-correlation algorithm with spatio-temporal gradient method for subpixel refinement is used. Detail of the algorithm can be found in Scarano (1999) and Sugii (2000). The smallest interrogation window is 8x16 pixels which corresponds to 249 x 585μm. The near-wall structure is observed from vector map of fluctuating in-plane velocity components and out-of-plane component of vorticity fluctuation. The shear layer structure is clearly shown by vorticity fluctuation and ejection and sweep motion is also observed. The mean velocity profile and statistics are calculated from 4000 samples of vector map by first taking temporal statistics and then spatial average along streamwise direction and compared with DNS in non-dimensional form using friction velocity. Since accurate measurement of friction velocity is essential for the comparison with DNS, using pressure gradient is not appropriate due to the relatively small pressure drop along the pipe. Therefore, curve-fitting method using near-wall turbulent model developed by McEligot (1984) is applied to calculate friction velocity from the velocity profile in buffer region.

Experimental study of MHD effects on turbulent flow of Flibe simulant fluid in circular pipe

Development of Piv Technique under Magnetic Fields and Measurement of Turbulent Pipe Flow of Flibe Simulant Fluid

EXPERIMENTAL INVESTIGATION OF TURBULENT HEAT TRANSFER OF HIGH PRANDTL NUMBER FLUID FLOW UNDER STRONG MAGNETIC FIELD

Turbulent Pipe Flow in a Transverse Magnetic Field: A Comparison Between PIV Measurement and DNS

Study of Heat Transfer Enhancement/suppression for Molten Salt Flows in a Large Diameter Circular Pipe: Part I: Benchmarking

Turbulent velocity profile measurement in circular pipe flow using particle image velocimetry technique

Mhd Effect on Flow Structures and Heat Transfer Characteristics of Liquid Metal-Gas Annular Flow in A Vertical Pipe

Direct Numerical Simulation of Liquid Metal Free-Surface Turbulent Flows Imposed on Wall-Normal Magnetic Field

Advances in Direct Numerical Simulation for MHD Modeling of Free Surface Flows

MHD Pressure Drop Measurement of PbLi Flow in Double-Bended Pipe

Direct Numerical Simulation of Unstable Stratified Turbulent Flow under a Magnetic Field

Experimental Investigation on Liquid-Metal Flow Distribution in Insulating Manifold under Uniform Magnetic Field

Direct numerical simulation of turbulent mixed convection in a vertical channel in a wall-normal magnetic field

Study on Thermal Mixing of MHD Liquid Metal Free-Surface Film Flow

MHD effects on turbulent dissipation process in channel flows with an imposed wall-normal magnetic field

DIRECT NUMERICAL SIMULATION OF TURBULENT FREE-SURFACE FLOW

Measurements of turbulence statistics and near-wall structure of fully developed pipe flow at high Reynolds number

Modeling of MHD Turbulent Heat Transfer in Channel Flows Imposed Wall-Normal Magnetic Fields under the Various Prandtl Number Fluids

Thermal Mixing Enhancement of Liquid Metal MHD Free-Surface Flow by Optimizing Vortex Generator Arrays

MHD turbulent flow with buoyancy by DNS

DNS of MHD Turbulent Flow with Buoyancy