Effect of Zn Addition on the Crystallization Process in Zr65al7.5ni10cu17.5 Metallic Glass

CF Li,A Inoue
DOI: https://doi.org/10.1016/s0925-8388(01)01377-9
IF: 6.2
2001-01-01
Journal of Alloys and Compounds
Abstract:Zr65Al7.5Ni10Cu12.5Zn5 and Zr65Al7.5Ni5Cu17.5Zn5 metallic glasses, which were obtained by adding Zn to the well-known glass-former Zr65Al7.5Ni10Cu17.5, were prepared by a melt-spinning method and the crystallization process was studied by differential scanning calorimetry (DSC), X-ray diffraction and transmission electron microscopy. Two exothermic peaks were observed in the DSC curves. The low temperature one corresponds to the simultaneous precipitation of an icosahedral quasicrystalline phase (I-phase) and the face centered cubic Zr2Ni (FCC–Zr2Ni) phase in the Zr65Al7.5Ni10Cu12.5Zn5 alloy. The initial precipitate for the Zr65Al7.5Ni5Cu17.5Zn5 alloy is a single I-phase. Since an I-phase does not occur in the crystallization process of Zr65Al7.5Ni10Cu17.5 metallic glass, the present results demonstrate that the addition of Zn is effective in promoting the precipitation of an I-phase, in addition to the previously reported noble metals. Further annealing leads to the precipitation of other stable crystalline phases, indicating the metastable character of the I-phase and the FCC–Zr2Ni phase. The reason for the change in the crystallization process caused by the addition of Zn was discussed on the basis of the chemical affinity and atomic radius of the constituent elements.
What problem does this paper attempt to address?