Abstract:The process of superhard particle breakage in the grinding zone of the fluidized bed opposed jet mill is investigated using the CFD-DEM (computational fluid dynamics-discrete element method) coupling method with the Tavares UFRJ Breakage Model in the present study. The effects of structural and operational parameters, such as target plate structure, nozzle position, air inlet velocity, and feed rate, on the equipment stress distribution, airflow velocity, pressure field, particle velocity, and cumulative particle size distribution are thoroughly studied to determine the optimal structural and operational parameters. Experimental validation is conducted, including scanning electron microscope (SEM) observation of particle morphology and analysis of particle size distribution of ground product particles. The simulation results indicate that the wear rate of the structure without a target plate is lower than that of the structure with a target plate in the grinding central zone. Therefore, the structure without a target plate is chosen for further investigation. The cumulative particle size distribution after grinding is influenced by nozzle position, air inlet velocity, and feed rate. The particle D50 is positively correlated with nozzle spacing and feed rate, while it is negatively correlated with air inlet velocity. The optimal grinding effect is achieved when the distance between the nozzle and the center of the grinding zone ranges from 52.5 mm to 72.55 mm, the air inlet velocity is 950 m/s, and the feed rate is 10.5 g/s. Through experimental investigation, it has been observed that when the feed rate is 10 g/s, the particle size distribution becomes more uniform. Furthermore, consistent trends in the cumulative particle size distribution in the experiment and simulation results can be found, which validates the present numerical model. It was observed that particles at low feed rates retain certain angular edges, while particle roundness increases at high feed rates.

Study on Dry Crushing Equipment of Flammable and Explosive Materials

Study on the Equipment and Technique of Bi-rolling Superfine Milling

The Producing Equipment of Micrometer and Nanometer Sheet Metal Powder

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Superfinishing Technology Test for Ceramic Cylindrical Rollers

A wet ball milling treatment of Zr-based AB2 alloys as negative electrode materials

Superfine Crushing of Hard Oak and Bamboo Charcoal with Bi-rolling Milling Technique

Study on the Main Promotion Factors of Powder Refinement in High-energy Ball Milling

Preparing Flake Silver Powder by High-Energy Ball Milling

The Study of Reamer Wear in Pulverizing Waste Printed Ciruit Board of Pulverizing Machine with Air Cooling

Study of the Cr3C2–NiCr Detonation Spray Coating

Study on toughening of Fe based amorphous coatings by ultra high speed laser cladding

Study on High Chromium Cast Iron Fracture Grinding Roll

Compressive combined grinding system with scattering separator

Comparative study on the characteristics of ball-milled coal fly ash

STUDY ON SURFACING MATERIALS AND TECHNOLOGY FOR HOT ROLLING MILL ROLLS

Dielectric Barrier Discharge Plasma Assisted Ball Milling Technology and Its Applications in Materials Fabrication

Study on Mechanical Properties and Microstructure of Cu20Fe80 Alloy Using the Mechanical Alloying

Research progress of Supercritical fluid technology to prepare Ultrafine explosive and Superfine mixed explosives

Research on the Grinding Process of Superhard Particles in the Fluidized Bed Opposed Jet Mill Based on the CFD-DEM Methodology

Preparation of Ultrafine CL‐20 by Wet Grinding Method and the Study on Its Properties