Abstract:Using wood biomass as opposed to petroleum/fossil feedstock to synthesize chemicals and monomers offers the value proposition of a reduced carbon foot print. A critical step in biomass utilization is to obtain the fermentable monomeric pentose and hexose sugar subunits from various lig-nocellulosic polymers. However, lignin is a three-dimensional amorphous polymer based on methoxylated phenylpropanoid units, and is crosslinks to different polysaccharides with covalent bond. The presence of lignin is a barrier to enzymatic hydrosis of cellulose by cellulases, as well as inhibiting fermentation to form products such as ethanol. Usually, there are three approaches to fractionate biomass into useful chemicals. The first one is extract lignin at high temperature and pressure. The second approach involves more severe conditions such as the temperatures and pressures used in gasification, or use the mineral acids at elevated temperatures to liberate sugars for fermentation. The third way is dissolution of biomass using ionic liquid to extract lignin, and then re-precipitation the cellulosic residue. In this paper, we investigate the lignin extraction uses a purpose designed ionic liquid (IL) 1 -butyl-3-methylimidazolium acesulfamate [BMIM]Ace at room temperature and open atmosphere. It was synthesized from the sugar acesulfamate potassium (Ace K), and with good property of greater thermal stability, increased viscosities, and inability to dissolve crystalline cellulose. In addition, it is of low cost and nontoxic, and is expected to interact with lignin owing to its aromatic character of anion. Organic solvents were firstly used in the extraction process, which reduce the viscosity of IL and increase the lignin yield. The lignin can be obtained by using acetone as the reconstitution solvent (IL/acetone 1:3, v/v), and approximately 11.5% and 96.5% of lignin and the reconstitution cellulose-rich material have been achieved in one dissolution/reconstitution cycle by fresh IL, respectively. It was found that the presence of some organic solvents mix with IL can increase the extraction efficiency. The regenerated ionic liquid showed good retention of structure and properties. The regenerated lignin fractions exhibited large molecular weights (M-w, 3700-7810 g mol(-1)). The physicochemical properties of the extracted lignin fractions were characterized by Fourier transform infrared (FT-IR), and high-performance anion exchange chromatography (HPAEC). The reconstitution cellulose-rich material can be serving as a valuable source for enzymatic saccharification for next step. These results indicate a potential approach in further optimization of the choice of low-cost Its combined with organic solvents for the efficient utilization of the wood biomass.

Extraction of Lignin from Pulping Black Liquor by Organic Acid

Highly efficient lignin removal from the waste liquor of chemical pulping with an integrated polyaluminium chloride-assisted acidification/activated carbon adsorption process

Pretreatment of black liquor from refined cotton production by acidification and adsorption using activated carbon fiber

Lignin recovery from spent alkaline pulping liquors using acidification, membrane separation, and related processing steps: A review

Precipitation and separation of lignin from kraft black liquor

Fractionation and quantitative structural analysis of lignin from a lignocellulosic biorefinery process by gradient acid precipitation

Enhanced Performance of Lignin Recovery with a Carbon Dioxide Acidification Method

Effect of Different Acids on Acidolysis of Black Liquid from Paper Making

Extraction of lignin from Chinese quince fruit by acetic acid solution at above atmospheric pressure: Yield distribution, structural characterization, and antioxidant activities

Fractionation of poplar wood with different acid hydrotropes: Lignin dissolution behavior and mechanism evaluation

A hydrotrope pretreatment for stabilized lignin extraction and high titer ethanol production

Surface Lignin Change Pertaining to the Integrated Process of Dilute Acid Pre-Extraction and Mechanical Refining of Poplar Wood Chips and Its Impact on Enzymatic Hydrolysis.

Comparing Physicochemical Characteristics and Depolymerization Behaviors of Lignins Derived from Different Pretreatment Processes

Fractionation of poplar through solid acid pretreatment assisted by mild alkali-1-butanol immersion to effectively produce xylose, glucose, and solid lignin

Extraction Of Lignin From Wood Biomass Using A New Ionic Liquid At Open Atmosphere

Efficient extraction of highly reactive lignin from waste mulberry branches

Optimizing Conditions for Using Deep Eutectic Solvents to Extract Lignin from Black Liquor

Kinetics of Lignin Separation during the Atmospheric Fractionation of Bagasse with p-Toluenesulfonic Acid

Effect of Alkali and 1,4-Butanediol Contents on the Extraction of Lignin and Lignin-Based Activated Carbon

Overview of Organic Acid Pulping

Comparative Evaluation Of Organic Acid Pretreatment Of Eucalyptus For Kraft Dissolving Pulp Production