Abstract:The super high-speed operation of the elevator will inevitably make the elevator bear significant aerodynamic load. Under the action of the aerodynamic load, the rubber on the outer ring of the guide roller will produce a certain deformation, which will cause the contact stiffness between the guide roller and the rail to change. Moreover, because the aerodynamic load is time-varying, the guide roller-rail contact stiffness will also show the time-varying characteristics. In view of this, considering the time-varying characteristics of the contact stiffness, a 17 degrees-of-freedom (DOF) dynamic model of the horizontal vibration of the super high-speed elevator is established in this paper; the Gaussian white noise is employed to simulate the excitations of guide, and the Savitzky–Golay filter is used to filter the excitations; based on Hertz elastic contact theory, the guide roller-rail contact stiffness model is established under the action of preload and aerodynamic loads; for the calculation of aerodynamic load, a user-defined file is compiled according to the actual running curve of the elevator to set the velocity inlet boundary condition, and CFD numerical simulation is used to obtain the aerodynamic load data of the whole running process of the elevator; finally, using Newmark-β method, the time-varying characteristics of the contact stiffness under the action of aerodynamic load are analyzed, so as to influence the horizontal vibration of the elevator. The results show that, under the action of aerodynamic load, the maximum change rate of contact stiffness is 5.2%, which has a significant impact on the horizontal vibration of the elevator, among which the vibration acceleration of the elevator in the X-direction increases by 16.97%. Therefore, the effect of aerodynamic load should be considered in the study of the dynamic response of the super high-speed elevator.

Effect Of Friction On The Slide Guide In An Elevator System

A New Friction Model for the Slide Guide in Elevator Systems: Experimental and Theoretical Investigations

Experimental And Theoretical Investigations On Friction Modeling Concerning Accelerations In Elevator Systems

Nonlinear Rate Dependent Friction Dynamics: Experiment and Theoretical Modeling

Measurement of Friction and Energy Consumption for Elevator Slide Guide System

CABLE SLIDING ANALYSIS CONSIDERING FRICTIONAL EFFECT

Vibration Analysis of High-speed Traction Elevator Based on Guide Roller-rail Contact Model

Study on Friction Characteristics of Sliding Interface of Feed System

Friction characteristics of moving joint surface from the micro and macro scale

Effect of Surface Micro-parameters on Contact Temperature of Sliding Electrical Contact

Modeling and Simulation of Vibrtion for Slide Guide System in an Elevator

Study on the Influence of Micro-Features in the Surface Topography of the Slider Raceway on the Dynamic Friction Factor of the Guide Rail Pair

A NEW DYNAMICAL FRICTION MODEL

Investigation of the contact stiffness variation of linear rolling guides due to the effects of friction and wear during operation

Time-varying characteristics of guide roller-rail contact stiffness of super high-speed elevator under aerodynamic load

Investigation on Wear Mechanism of Elevator Brake Sluice Bar

Effects Of Angular Motion On Planar Rough Surfaces Contact From Static To Sliding

Experimental Study and Simulation Analysis on Friction Behavior of A Mechanical Surface Sliding on Hard Particles

Some Advances on Investigating Friction Characteristics of Rolling Guide Ways

Effect of friction on the dynamic analysis of slider-crank mechanism with clearance joint

Study on Sliding Friction Coefficient of High-speed Wheel-rail Materials