Abstract:AbstractThe search for suitable friction materials for high-speed train is an attractive but difficult problem. In recent years, a variety of different novel friction materials were fabricated to meet the aims of high loads and speeds under ambient environment. Carbon fiber-reinforced carbon composites (C/C), carbon fiber-reinforced silicon carbide composites (C/C-SiC) and metallic composites fabricated by powder metallurgy are three excellent materials among them. Here a comparison of these three different materials working as brake pads, coupled with high-density C/C-SiC brake disk, was described. All the experiments were conducted using the same procedure with increasing initial braking speed (the rotation speed of brake disk at the beginning of braking process) from 30 to 59 m/s and constant load of 1.25 MPa, simulating the real working condition of high-speed train. The coefficient of friction (COF) and wear rates of three materials were compared and analyzed. During experiments, the COF of metallic and C/C pads remains nearly constant at 0.31 and 0.22, respectively, with increasing braking speed, while that of C/C-SiC exhibits a parabola. These different trends of COF may be attributed to the distinctive forming processes of friction film on the top of contact surfaces. Meanwhile, the wear rates of metallic composites increase rapidly from 683 to 1803 mm3/MJ with initial braking speed, while C/C-SiC presents the highest wear loss of 1887 mm3/MJ at 49 m/s and lowest value of 315 mm3/MJ at 59 m/s. Interestingly, the wear rate of C/C composites, due to the appropriate bonding strength of matrix/fiber and relatively high shear stress, decreases from 3698 to 903 mm3/MJ with increasing initial braking speed, which does not consist with pre-existing paper. Thus, metallic pads presented the lowest wear rates at lower speed (<49 m/s) but the highest at high speed, while C/C-SiC composite pads showed the greatest wear resistance at high speed. This investigation of three different friction materials will enhance our understanding of these friction materials and benefit the selection and safe application of high-speed train friction materials.

Study on Sliding Friction Coefficient of High-speed Wheel-rail Materials

Application Status and Research Progress of Brake Disc Materials for High-speed Train

Thermal–Mechanical Coupling Analysis of Wheel–Rail Sliding Friction under Two-Point Contact Conditions

Research on wheel-rail dynamic interaction of high-speed railway under low adhesion condition

Experimental study of the effects of temperature and humidity on the wear and damage behavior of U71Mn rail steel

Study on influence of friction conditions on the friction and wear performance of high-speed rail brake materials under high humidity environment

Effects of solid friction modifier on friction and rolling contact fatigue damage of wheel-rail surfaces

Sliding Friction and Wear Characteristics of Newly Developed High-Power Locomotive Wheel Steels

An experimental study on the effects of friction modifiers on wheel–rail dynamic interactions with various angles of attack

Influence of wheel profile wear coupled with friction coefficient on the dynamic response of subway vehicles

Study of wear performance of wheel and rail steels under dry sliding conditions

Experimental Investigation on the Wear and Damage Behaviors of Machined Wheel-Rail Materials under Dry Sliding Conditions

Influence of material properties on the high-speed wheel-rail rolling contact behaviour

Study on the friction-wear performance of friction pair materials

Influences of friction self-excited vibration characteristics of various types of high-speed trains on rail corrugations in braking sections

Correlation of microstructure and hardness distribution of high-speed train wheels under original and service statuses

Effects of Lubricating Conditions on Wear Performance of U77MnCrH Rail

Analysis of Wheel Wear and Wheel-Rail Dynamic Characteristics of High-Speed Trains under Braking Conditions

Comparison of Friction and Wear Behavior Between C/C, C/C-SiC and Metallic Composite Materials

Study on the Interaction between Wheel Polygon and Rail Corrugation in High-Speed Railways

Research Progress of High-Speed Wheel–Rail Relationship