Finite element analysis of a customized coronoid prosthesis for traumatic coronoid deficiency
Daofeng Wang,Dou Xiong,Jiabing Zhang,Wupeng Zhang,Shuang Wang,Xiaolin Tian,Zhengfeng Jia,Huanyu Li,Cheng Xu,Jiantao Li
DOI: https://doi.org/10.1016/j.jse.2023.11.009
IF: 3.507
2024-01-05
Journal of Shoulder and Elbow Surgery
Abstract:Background Traumatic coronoid deficiency with persistent elbow instability is a challenging condition. Autologous bone graft reconstruction is often associated with a range of additional clinical problems and the outcome is often unpredictable. The purpose of this study was to design a prosthetic device that can reconstruct coronoid deficiency of any height and to evaluate its mechanical properties using finite element analysis. Materials and Methods A customized coronoid prosthesis was designed based on image registration, automatic measurement and computer-aided design. After pilot study and sample size calculation, image data collected from six patients who underwent bilateral complete upper extremity CT scans were reconstructed. The test was divided into three groups: coronoid intact, prosthesis and autograft. Regan-Morrey type II and autologous olecranon osteotomy models were established. The prosthesis and autogenous olecranon were assembled to the coronoid base. Stress was applied axially along the proximal humeral diaphysis and implant micromotion and contact mechanics of the humeroulnar joint were measured at 30°, 45°, 60° and 90° of joint flexion respectively. Results At all flexion angles, the maximum stress on the coronoid articular surface was significantly reduced in the prosthesis and autograft groups, with the reduction being more significant in the latter ( P < 0.001). With increasing flexion, the maximum stress at the coronoid articular surface increased significantly after autograft reconstruction (7.2 to 68 MPa, P < 0.001), whereas the humeroulnar joint obtained a similar contact mechanics pattern to that of the control group after prosthetic reconstruction. As the flexion angle increased, the relative micromotion of both the prosthesis and autograft increased significantly (0.5-1.6 vs 0.2-1.2, P measure time < 0.001, P groups < 0.001). Contact pressure and center-of-force paths of the humeroulnar joint experience abrupt stress changes at approximately 60° of flexion. Conclusion The contact stress pattern in the humeroulnar joint is similar in prosthesis and intact coronoid groups. Autograft reconstruction increases contact stresses at the articular surface and alters the joint center-of-force path. The "stress surge phenomenon" in the humeroulnar joint surface before and after 60° of flexion may be one of the mechanisms of traumatic elbow degeneration.
surgery,orthopedics,sport sciences