Abstract:PurposeIn order to achieve a high-precision measurement of the incident and the reflected power, a WR1800 rectangular waveguide directional coupler with high directivity and high power level has been in-house developed. Multiple couplers will be installed in the 500-MHz high-power radio-frequency transmission lines delivering 200-kW continuous-wave power for the High Energy Photon Source (HEPS).MethodsThe directional coupler adopts the design scheme of primary and secondary transmission lines and coaxial coupling-head structure. The shape and dimensional parameters of the coupling head were carefully optimized by using microwave simulation codes. An optimum directivity of 64 dB was achieved in simulations.Results and conclusionsA prototype coupler was subsequently manufactured, and its directivity was measured to be 48.2 dB following a rigorous calibration procedure, largely exceeding the design goal and the commercial product. The coupler was then connected to an existing 500-MHz klystron system, and a high-power test with short-circuit termination was conducted. The high directivity of the coupler was confirmed up to 200 kW. During the 6 hours of power aging with continuous-wave 200 kW in a standing-wave setup, no performance degradation was observed on the coupler. The coupler temperature was measured to be 20 ∘documentclass[12pt]{minimal}usepackage{amsmath}usepackage{wasysym}usepackage{amsfonts}usepackage{amssymb}usepackage{amsbsy}usepackage{mathrsfs}usepackage{upgreek}setlength{oddsidemargin}{-69pt}egin{document}$$^{circ }$$end{document}C above the ambient environment. The design requirements were comfortably fulfilled. These constitute the first in-house development of a large-size waveguide directional coupler with high directivity and high power level for HEPS. The design, fabrication, and performance tests of the directional coupler are presented.

Development of Longitudinal Coupling Impedance Measurement Platform for Bepcii

UPDATING THE LONGITUDINAL COUPLING IMPEDANCE MEASUREMENT PLATFORM FOR BEPC

Application of TRL Calibration in Longitudinal Coupling Impedance Measurement Platform for BEPCII

LONGITUDINAL BROADBAND IMPEDANCE MEASUREMENT SYSTEM

A Dual-Band Coupled-Line Coupler with an Arbitrary Coupling Coefficient

A Multilayer Dual-Band Coupler Based on Composite Right/left-Handed Folded Substrate Integrated Waveguide

A Wideband Contactless Electrical Impedance Tomography System

Developing A Special Rf Connector for Coaxial Impedance Measurement Platform

Improvement of Longitudinal Coupling Impedance Measurement Bench at National Synchrotron Radiation Laboratory

Longitudinal Broadband Impedance Measurement System by Coaxial Line Methods

High-Order Mode-Matching-Based Single-Cavity Coaxial Transducer for Broadband Measurement of Complex Permittivity

Design and Test of Voltage and Current Probes for EAST ICRF Antenna Impedance Measurement

Design Method of Multi-Sine Signal for Broadband Impedance Measurement Considering Frequency Coupling Characteristic

Beam Coupling Impedance Measurement Based on Goubau Line Method

Design of High-Frequency Differential Line for Ex Probe Calibration

Horizontal Test for BEPCII 500MHz Spare Cavity

Design and Microwave Measurement of a Broadband Compact Power Coupler for Sheet Beam Traveling Wave Tubes

Longitudinal and Transverse Measurement to Evaluate the Beam Impedance on a Ceramic Ring-Loaded Thin-Wall Vacuum Chamber in BRing at HIAF

High Power Conditioning of RF Couplers for the BISOL Linac

Development of a 500-MHz waveguide directional coupler with high directivity for HEPS