Abstract:Few studies/bodies of data are available in the open literature on the topic of mechanical material characterisation and structural performance for direct/inline compounded long fibre thermoplastic (LFT) automotive parts, particularly incorporating carbon fibre. Therefore, this study aimed to comprehensively document the mechanical properties of a seatback for a lightweight automotive seating design, compression moulded from carbon fibre/polyamide 66 on a Dieffenbacher LFT-D manufacturing line. The methodology consisted of extracting and characterising mechanical behaviour of tensile specimens from full seatback components and completing quasi-static and low velocity impact loading on these seatbacks. Both longitudinal and transverse charge placements within the compression mould were considered. Main findings from the tensile tests noted a dependency of the mechanical properties based upon the location from which specimens were extracted; from the charge region, the elastic moduli in the 0° and 90° directions were similar (0°: 14.0GPa & 90° 15.9GPa with coefficients of variation (CoV) of 56% and 36%, respectively) or, for the case of specimens extracted from the flow region, exhibited significant anisotropy (elastic moduli in the 0° direction 9.79GPa and 90° direction 21.6GPa, with CoV's of 16% and 23%). In terms of anisotropy of the full seatback component, under low velocity impact loading a local force maxima was observed for seatbacks produced with a longitudinal charge orientation at deflections of approximately 15 to 20mm. No local maxima were consistently observed for transverse charge seatbacks. In terms of rate effects, stiffness was 550% higher for low velocity impact with respect to quasi-static loading. Digital image correlation identified a greater level of deformation, particularly away from the indenter, for quasi-static loading. Catastrophic failure occurred at larger deflections for low velocity impact (36% increase for longitudinal charge placement, 24% for transverse). The results of this investigation have practical applications for engineers in industry considering direct/inline compounded carbon fibre LFT materials in cases where quasi-static and dynamic loading will be present, for example, automotive chassis/body structural components.

Experimental Study of Glass-Fiber Mat Thermoplastic Material Impact Properties and Lightweight Automobile Body Analysis

Mechanical Property of Long Glass Fiber Reinforced Polypropylene Composite: From Material to Car Seat Frame and Bumper Beam

Use of high strength steel sheet for lightweight and crashworthy car body

Experimental and predictive analysis of the molding behavior of a PA6 glass mat thermoplastic (GMT)

Research on Dynamic Response and Fracture Properties of Metal Materials for Vehicle

Low Velocity Impact of Carbon Fiber Aluminum Laminates

Analysis on effect of injection residual stress on impact resistance of composite wheel made of long glass fiber reinforced thermoplastic

Experimental study on mechanical behavior of PVB laminated glass under quasi-static and dynamic loadings

Application of Aluminum Alloy to Lighten Auto-body

Experimental characterisation of the mechanical properties of a carbon fibre/PA66 LFT automotive seatback under quasi-static and impact loading

Application of Carbon fiber-reinforced plastic composite material in automotive bumper

Experimental investigation on constitutive behavior of PVB under impact loading

Impact behavior of long glass fibre reinforced aluminum metal matrix composite prepared by friction stir processing technique for automotive

Experimental investigation on the compression‐after‐double‐impact behaviors of GFRP laminates embedded with aluminum mesh

Impact Energy Dissipation and Quantitative Models of Injection Molded Short Fiber-Reinforced Thermoplastics

On the crashworthiness of thin-walled multi-cell structures and materials: State of the art and prospects

Experimental and numerical studies on bending characteristics of woven CFRP reinforced aluminum thin-walled automotive structures

Numerical and Experimental Analysis of Stress-Strain Characteristics in DP 600 and TRIP 400/700 Steel Sheets

Top-hat crashboxes of thermoplastic fibre-metal-laminates processed in one-step thermoforming: Experimental and numerical study

Mechanical properties study on sandwich hybrid metal/(carbon, glass) fiber reinforcement plastic composite sheet

Study of Low-Velocity Impact Behavior of Hybrid Fiber-Reinforced Metal Laminates