Abstract:This paper introduces a straightforward control strategy aimed at the reduction of current fluctuations within the low-frequency domain of open-loop V/f control in induction motor drives. Traditional control techniques necessitate the addition of a current compensator based on motor parameters and the use of digital filters such as band-pass or high-pass filters. These methods, however, rely on precise motor parameters and involve complex filter design and implementation. The proposed control is capable of suppressing current fluctuations without controlling the slip of the induction motor. The proposed control strategy generates the forced rotation angle and command input voltage using the V/f block and outputs the d-axis voltage using a proportional integral controller to keep the d-axis current constant at zero. The difference between the command input voltage and the d-axis voltage is applied as the q-axis voltage and then applied through SVPWM. In order to verify the effectiveness of the proposed control, the proposed control is implemented and analyzed using power simulation based on the results of the analysis of the causes of current fluctuations in the induction motor. Finally, the effect of suppressing current fluctuations of the induction motor is verified through experimental results. In the 10~19 Hz range, where the conventional V/f control method resulted in current fluctuation rates exceeding 10% and peaking at 113.3% at 13 Hz, the proposed method suppressed the fluctuation rate to below 8.6% across all frequencies. This paper validates the effectiveness of the proposed control strategy through these results.

Variable Structure Approaches for Current Control in Vector Controlled Inverter-Induction Motor System.

Current Control Strategy of Electronic Pole-Changing for Multiphase Induction Motors

Predictive Current Control for Seven-Phase Induction Motor Based on the Optimal Operating Time of Four-Dimensional Vector

Variable-structure torque control of induction motors using space vector modulation

Accurate Two-Degree-of-freedom Discrete-Time Current Controller Design for PMSM Using Complex Vectors

Application of Flux-Weakening Control in Variable Frequency and Adjustable Speed Vector Control System

An I/f Control Method With Closed-loop Regulation of Current Vector for Surface Permanent Magnet Synchronous Motor Drives

SVPWM-based predictive current controller for four-quadrant induction motor drive system

A V/Hz Based Maximum Torque Per Volt Control in Flux-Weakening Region for Interior Permanent Magnet Synchronous Motors

Pwm Control Of A 5-Level Single-Phase Current-Source Inverter With Controlled Intermediate Dc-Link Current

Simplified V/f Control Algorithm for Reduction of Current Fluctuations in Variable-Speed Operation of Induction Motors

Novel space vector PWM method for inverter-fed induction motors

The PMSM DTC Based on Variable Structure Sliding Mode

Vector Control Algorithm Based on Different Current Control Switching Techniques for Ac Motor Drives

Design of Complex Vector Controller for High-power Induction Machine Drive

A Variable Switching Frequency Space Vector Pulse Width Modulation Control Strategy of Induction Motor Drive System with Torque Ripple Prediction

A New Intelligent Control Strategy of Combined Vector Control and Direct Torque Control for Dynamic Performance Improvement of Induction Motor Drive

Comparison of Methods for Current Sampling in SVPWM Inverter

Implementation of Direct Torque Control Scheme for Induction Machines with Variable Structure Controllers

Development and Analysis of Pulse Width Modulation Techniques for Induction Motor Control

New Control Technology Of Doubly-Fed Induction Machine Based On Current-Source Dual-Pwm Converter