Abstract:This study mainly focuses on the preparation technique of Ni-rich NCA hydroxide by a Couette–Taylor flow reactor (CTFR), by systematically optimizing the preparation parameters, including cylinder rotation speed and calcination temperature to study its electrochemical performance. Because of the uniform mixing and constant fluid motion of the Taylor vortex, we obtained spherical and uniform Ni0·80Co0·15Al0·05(OH)2 particles. The rotation speed of the inner cylinder determined the degrees of particle agglomeration and growth. X-ray diffraction and Rietveld refinement revealed that the sample prepared at 600 rpm had relatively large particles and a high degree of crystallinity; when calcined to 750 °C, it featured much smaller primary particles, a comparatively lower degree of cation mixing, and better layer structure ordering. The Ni-rich LiNi0·80Co0·15Al0·05O2 prepared under the optimal conditions delivered a high discharge capacity of 190.6 mAh g−1 at 0.1C, on par with that of commercially available NCA powders; it also exhibited a remarkable improvement in rate capability, with a discharge capacity of 138 mAh g−1 at 10C (101 mAh g−1 for a commercial sample). In long cycle life tests, the prepared NCA sample retained a high capacity (87.4%) after 100 cycles at 1C, compared with 70.0% for the commercial sample. Furthermore, cyclic voltammetry and electrochemical impedance spectroscopy demonstrated the importance of the calcination temperature on the electrochemical performance and structural stability of our Ni-rich cathodes. Our as-prepared NCA cathode materials, obtained using a CTFR, appear to have great potential for application in Li-ion batteries.

Synthesis of LiNi0.8Co0.15Al0.05O2 cathode materials under elevated oxygen pressure

Enhanced Electrochemical Performance of LiNi0.8Co0.15Al0.05O2 Cathode Material via Li2TiO3 Nanoparticles Coating

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

Enhancing high-voltage performances of nickel-based cathode material via aluminum and progressive concentration gradient modification

Synthesis of LiNiO2 cathode materials with homogeneous Al doping at the atomic level

Preparation of LiNi0.8Co0.20-xAlxO2 by Carbonate Co-Precipitation Process

Synthesis and Electrochemical Characterization of LiNi0.5Co0.2Mn0.3O2 Cathode Material by Solid-Phase Reaction

Effects of Oxygen Pressurization on Li + /Ni 2+ Cation Mixing and the Oxygen Vacancies of LiNi 0.8 Co 0.15 Al 0.05 O 2 Cathode Materials

Synthesis and Characterization of LiNi0.6Mn0.4−xCoxO2 As Cathode Materials for Li-ion Batteries

The Performance of Li-Ni-Co-O Cathode Materials Synthesized in Air Atmosphere for Cathode Materials for Lithium-Ion Battery

Li[Li0.20Ni0.128Co0.136Mn0.536]O2 Cathode Material for Lithium-Ion Batteries

In Situ X-ray Diffraction and Thermal Analysis of LiNi0.8Co0.15Al0.05O2 Synthesized Via Co-Precipitation Method

Synthesis And Characterization Of Li(Li0.2mn0.4fe0.2m0.2)O-2 (M=Co, Ni, Cr, Al) Cathode Materials For Li-Ion Batteries

Enhanced Li-ion Intercalation Kinetics and Lattice Oxygen Stability in Single-Crystalline Ni-rich Co-poor Layered Cathodes

Co‐doping of Al3+ and Ti4+ and electrochemical properties of LiNiO2 cathode materials for lithium‐ion batteries

Structural and Electrochemical Characteristics of Co and Al Co-Doped Lithium Nickelate Cathode Materials for Lithium-Ion Batteries

Using a Couette–Taylor vortex flow reactor to prepare a uniform and highly stable Li[Ni0·80Co0·15Al0.05]O2 cathode material

Synthesis and Characterization of Spherical LiNi0.75Co0.2Mg0.05O2 Cathode Materials

LiNbO3 Coating and F- Doping Stabilize the Crystal Structure and Ameliorate the Interface of LiNi0.88Co0.06Mn0.03Al0.03O2 to Improve the Electrochemical Properties and Safety Capability

Synthesis and Properties of Single-Crystal Ni-rich Cathode Materials in Li-ion Batteries