Abstract:In linear FM signal detection applications such as communications and radar, the pulse width of the signal can vary by hundreds of picoseconds, requiring the acquisition system to have higher acquisition performance and trigger performance to acquire and capture signals with small variations in pulse width. As one of the advanced trigger functions of a data acquisition system, pulse-width trigger has the ability to detect the pulse width of the input signal in real time and control the acquisition process in order to capture the signal that meets the conditions of pulse-width trigger. With the increasing frequency of the signal, the high-speed acquisition system is required not only to have the ability to capture small changes in the signal pulse width, but also to have a higher ability to detect the minimum pulse width. In high-speed acquisition systems, the traditional pulse-width trigger is realized by the analog pulse-width trigger. The analog pulse-width trigger has the advantage of real-time, but it also has the problem of large trigger jitter and low trigger accuracy due to the non-linear lead of the high-speed analog device and the analog-digital synchronization. This paper proposes a high-precision digital pulse-width trigger method. The method adopts the design of synchronizing the sampling data with the trigger data source, which solves the problem of trigger jitter in analog pulse-width trigger. The digital pulse-width trigger uses a method of converting high-speed parallel sampling data into parallel feature data that can characterize the edge features of the pulse signal. Then, according to the characteristics of the starting edge and the ending edge of the pulse width, the pulse width of the pulse signal is calculated. Finally, the pulse width trigger judgment is performed, and the trigger point position is obtained in real time to achieve the high-precision pulse width trigger. The method is implemented in a 10GSPS data acquisition system using an ADC+FPGA architecture. After testing, the minimum detectable pulse width of the digital pulse-width trigger is 200ps, and the pulse-width trigger jitter is less than 100ps.

The Design of 1 Gsps Real-Time Sampling System for Transient Pulsed Signal

An ultra-high-speed front-end intelligent digital transmission system for high-intensity pulsed radiation field diagnosis

Research of Wireless Electrocardiograph Signal Sampling System

WIDE AREA MEASUREMENT AND REAL-TIME TRANSMISSION SYSTEM FOR PHASOR DATA UNDER NETWORK COMMUNICATION MODE

Equivalent Photoconductive Time-Domain Sampling for Monitoring High-Speed Terahertz Communication Signals

Broadband Terahertz Equivalent-Time Sampling System Based on a Photoconductive Antenna

A Full Digitizing Design of Measuring Systems in Diagnosing of High-Intensity Pulsed Radiation Field

Miniature Optical Signal Transmission System for PDN Noise Measurement

Software Development Based on High Speed PC Oscilloscope for Automated Pulsed Magnetic Field Measurement System

Pulse Transmission Simulation in the Systems Including Diffraction Components by Real Ray Trace

A Study on High-Speed Data Acquisition System for Single Ended Traveling Wave Fault Location

A PXI-based Multi-channel Data Acquisition System for Fast Transient Pulses

Design of data acquisition system for distributed optical fiber sensor

A PXI-based, Multi-channel Ultra-fast Data Acquisition System for Transient Pulsed Signals

A beam phase and energy measurement system based on direct RF signal IQ under-sampling technology

The Circuit Design for a Transient Elastography System and Its Improvement Design

Research On The Measurement Of Transient Parameters And Fiber Isolating Technology Under Severe Emi Environment

Real-time frequency measurement based on parallel pipeline FFT for time-stretched acquisition system

Design of a new internal synchronous ground penetrating radar receiver

Pulse-Width Trigger Method in 10GSPS Data Acquisition System

Real-Time Data Acquisition for Long-Distance Reflective Ghost Imaging Experiment