The effect of cyclic oxidation-reduction pretreatments on an amorphous Ni80P20 catalyst: an XPS/UPS/ISS study

J DENG,H CHEN,X BAO,M MUHLER
DOI: https://doi.org/10.1016/0169-4332(94)90291-7
IF: 6.7
1994-01-01
Applied Surface Science
Abstract:As-prepared amorphous Ni-P alloys are known to be rather inactive for the hydrogenation of hydrocarbons and carbon monoxide. The active state is generated usually after cyclic treatments with O2 and H2 at temperatures far below the bulk recrystallization temperature. X-ray photoelectron spectroscopy (XPS), ultraviolet photoelectron spectroscopy (UPS) and ion scattering spectroscopy (ISS) were applied to monitor the chemical changes of an amorphous Ni80P20 alloy under conditions close to those used for pretreating technical catalysts. Exposure to O2 at 403 K resulted in a mixed oxide layer with a thickness of about 3-5 monolayers containing Ni3+ ions and P in the formal oxidation state +5. After reduction in H-2 and subsequent O2 exposure at 513 K, the surface region involving at least 30 monolayers was found to be oxidized to NiO. Both XPS and ISS measurements demonstrated the absence of phosphorus in the oxide layer. After rereduction at 553 K the surface region was observed to consist of Ni3P which remained unchanged when heating beyond the recrystallization temperature of about 650 K. The active state generated during the final rereduction of the Ni-P catalyst below the bulk recrystallization temperature is therefore formed by the diffusion of P into the Ni overlayer yielding crystalline Ni3P. The increase in catalytic activity of the initially amorphous catalyst is assumed to be due to the surface restructuring during the redox pretreatment.
What problem does this paper attempt to address?