Abstract:PLL frequency synthesizers with low jitter are essential for mm-Wave high-speed wireless communication systems and data converters. By doing away with the frequency doubler, low jitter synthesizers with the 2 ND harmonic output can simplify their architecture. Additionally, to produce high-quality local oscillator signals for 2ND harmonic output, it is beneficial to suppress the fundamental frequency component at 2 ND harmonic output. In general, lowering the voltagecontrolled oscillator's phase noise (PN) and reducing the PLL's bandwidth to suppress in-band noise are the two most popular ways to minimize PN of PLL. The phase noise of N-core VCO reduce PN by 10logN, which is an effective method for obtaining low PN. Additionally, increasing the reference clock frequency hence decreasing the loop frequency division ratio can decrease PN. Literature [1] used a reference clock frequency of 500MHz with 175mW to implement the PLL of 52-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter. Ref. [2] adopted a folded transformer-based series resonance CMOS VCO, the PN of which achieved -130.8dBc/Hz@1MHz, consumed 242mW while reducing the core area. Ref. [3] uses a clock frequency of 250MHz to reduce the overall contribution of VCO through wideband PLL, while suppressing the noise introduced by the reference clock through the design of double-sampling phase detector (SPD). Ref. [4] uses the high gain of phase-frequency detector (PFD) with time amplification to suppress the gain of CP, thus achieving the performance of 60-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter. This study presents the construction of a PLL based on a 4-core resistance-synchronized VCO that achieves 47-fs <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">rms</inf> Jitter and produces 2 ND harmonic with fundamental frequency suppression.

Stable Backward Reachability Correction for PLL Verification with Consideration of Environmental Noise Induced Jitter

Control of phase locked loop for wind power generation under non-ideal grid conditions

A High Swing Charge Pump with Current Mismatch Reduction for PLL Applications

Integer-N PLLs Verification Methodology: Large Signal Steady State and Noise Analysis.

A 4.7ghz Synchronized-Multi-Reference PLL with In-Band Phase Noise Lower Than Reference Phase $\text{noise +20}\Text{logn}_{\mathrm{d}\mathrm{i}\mathrm{v}}$

Research on the Influence of Phase Locked Loop Nonlinearity on Impedance Measurement for Stability Analysis

Double-Sided Modeling and Stability Analysis for Symmetrical PLL-Synchronized VSC in Weak Grid

Polar-Frame-Based Modeling and Small-Signal Stability Analysis of DDSRF-PLL: On the Different Implementation Structures Effect

Low Jitter and Low Power PLL : Towards the Utopia

A Multireference PLL: Theory and Implementation

A 28.8-to-43.2 GHz 79.8 fs$_{\mathrm{rms}}$ Jitter and $-$78.5 dBc Reference Spur PLL Exploiting Complementary Mixing Phase Detector With Mismatch Calibration

Supply-Noise Interactions among Submodules Inside A Charge-Pump Pll

On Transient Instability Mechanism of PLL-Based VSC Connected to a Weak Grid

Experimental Analysis of Substrate Noise Effect on PLL Performance

Three-phase digital phase-locked loop based on synchronous reference frame

Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur

All Digital Phase‐locked Loop with Nonlinear Multilevel Quantized Phase Comparator

Nonlinear analysis of the synchronous reference frame phase-locked loop under unbalanced grid voltage

IEEE ASSCC 2023/ Session 10/ Paper 10.5.

A 0.4-Ps-jitter −52-Dbc-spur Synthesizable Injection-Locked PLL with Self-Clocked Nonoverlap Update and Slope-Balanced Subsampling BBPD

Analyses and Enhancement of Linear Kalman-Filter-Based Phase-Locked Loop