Abstract:With more and more widely used in the industrial field, Active Magnetic Bearings (AMB) have bigger challenge, such as the size and the load capacity are larger than before. In order to increase the reliability of the whole system, a lot of aspects have to be improved to adapt some special industrial requirements. Just like the 10MW high temperature gas-cooled test module reactor (HTR-10GT) with the core made of spherical fuel elements, which was designed and constructed by the Institute of Nuclear and New Energy Technology of Tsinghua University in China, take the AMB as the support bearings. HTR-10GT is the reactor with 3.5 meter long rotor, 230mm diameter, and 15000rpm Rated speed. Since there are some difficulties in HTR-10GT including the blade stages, small gap and so on, the high precision control on magnetic bearing is required very much. Once any part in the system is out of work, the rotor would happen to vibrate, which will lead to turbine blades scraping. The consequences could be disastrous especially when the system is in full power at the rated speed [1]. As you know, the electronic control system is the weakest point in AMB, both in operating site and the control room. Therefore, before engineering applications, the electronic control system must be tested for Electromagnetic Compatibility (EMC). Based on the experimental results, some design would be optimized, to improve anti-interference capability to meet the requirements of HTR-10GT. This paper describes the testing process and gives some solutions for EMC problems during the Electro Magnetic Susceptibility (EMS) test, such as the grounding, cable, wiring, filtering etc. These methods are the fundamental basis for reducing interference and improving the reliability of AMB in the HTR-10GT.

Research on Measurement of Novel Rotating Electromagnetic Heating Machine

Research on the Thermal Power of the Novel Rotating Electromagnetic Heating Machine

Research on the Algorithm and Performance of the Heat Transfer of the Novel Rotating Electromagnetic Heating Machine

Fudamental Reasearch on Magnetization of Water Medium by Novel Rotating Electromagnetic Heating Machine

Solution of the 3D electromagnetic equation and research on related electromagnetic parameters of the novel rotational electromagnetic heating machine

Research on the Relationship Between Thermal Powers and Structure Parameters of the Rotational Electromagnetic Heater

Fundamental Research on the Third Function of Rotating Electric Machine

Analysis Of Novel Rotating Electromagnetic Heater Based On The Concept Of The Third Function Of Rotational Motor

Lumped Parameter Thermal Model and Computation of Temperature Rise of Rotational Electromagnetic Heater

Effect of Rotating Electromagnetic heating technology on corrosion and scale

Modeling and Investigation of Thermal Characteristics of A Water-Cooled Permanent-Magnet Linear Motor

THE ELECTRO MAGNETIC COMPATIBILITY TESTS FOR THE AMB SYSTEM ON HTR-10GT

Electromagnetic and Thermal Coupling Analysis of a Water-Cooled Double-Sided Permanent Magnet Linear Synchronous Motor

Measurement of Three-Dimensional Magnetic Properties with Feedback Control and Harmonic Compensation.

Simulation and Test for the Thermal Behaviour of a Prototype Synchronous Generator with HTS Armature Windings

Investigation Of The Cooling And Thermal-Measuring System Of A Compound-Structure Permanent-Magnet Synchronous Machine

Analysis of a novel rational heating device by using permanent magnets

Thermal Analysis and Experimental Validation of a 30 kW 60000 r/min High-Speed Permanent Magnet Motor With Magnetic Bearings

AC Rotating Electric Machine Theory and Applicatuin in Food Heater

Design and Experiments of Electromagnetic Heating Forming Technology