Stress analysis on structure defect with different post core materials and full crown restoration of the permanent mandibular first molar

田力丽,李凌旻,谢秋菲,麦汉超
DOI: https://doi.org/10.3969/j.issn.1001-0025.2005.06.004
2005-01-01
Abstract:Objective:To analyse the stress of 3-dimensional finite element models of cast NiCr alloy post core and crown and Au alloy post core and crown restoration for greater distal occlusal teeth defect of the mandibular first molars through root canal therapy.Methods:Three-dimensional finite element models of the maximum distal occlusal structure defect without involving pulp chamber wall and involving pulp chamber wall with cast NiCr alloy post core and crown and Au alloy post core and crown restoration were established by use of the advanced 3-dimensional laser scanning and 3-dimensional computer assisted design technique.The Mohr strength theory was applied for comparing the maximum Mohr stress value of dentin and stress concentration areas in four models under four different loads.Results:Within the maximum,vertical and inclined loads,the maximum Mohr stress values of dentin of the two kinds of post core and crown restorations were obviously smaller than the stretch limit strength of dentin.The maximum Mohr stress value of NiCr alloy post core and crown was obviously greater than that of Au alloy post core and crown and the stress concentration area of NiCr alloy post core and crown was prone to transfer to root parts under the maximum and horizontal loads.Under horizontal load,the maximum Mohr stress value of dentin increased markedly and close to or greater than the stretch limit of dentin.Conclusion:Au alloy post core and crown is superior to NiCr alloy post core and crown.
What problem does this paper attempt to address?