Abstract:The basic methods of time-correlated single-photon counting are outlined briefly, and the advantages of rapid repetition-rate pulsed lasers as light sources in this experiment are outlined. Application of the method to time-resolved fluorescence anisotropy is described. The basic principles of time-correlated single-photon counting have been the subjects of many reviews1-6. The method relies on the basic concept that the probability distribution for emission of a single-photon following excitation gives the actual intensity against time distribution of all photons emitted, thus by sampling the time of single-photon emission following a large number of excitation pulses, the probability distribution is created. The experiment is carried out as follows, with reference to Figure 1. A trigger T. which could be a photomultiplier, an antenna pick-up, or a logical synchronising pulse from the electronics pulsing the excitation source, generates an electrical pulse at a time exactly correlated with the time of generation of the optical pulse. The trigger pulse is routed, usually through a discriminator, to start input of the time-to-amplitude converter, (TAC) which initiates charging of a capacitor. In the meantime the optical pulse excites the sample, which subsequently fluoresces. An aperture is adjusted so that at most one photon is “detected” for each exciting event. The signal resulting from this photon stops the charging ramp in the TAC, which puts out a pulse, the amplitude of which is proportional to the charge in the capacitor, and hence to the time difference between START and STOP pulses. The TAC output pulse is given a numerical value in the analogue-to-digital converter and a count is stored in the data storage device in an address corresponding to that number. Excitation and data storage are repeated in this way until the histogram of number of counts against address number in the storage device has enough data so that it represents, to some required precision, the decay curve of the sample. If deconvolution is necessary, the time profile of the excitation pulse is collected in the same way by replacing the sample by a light scatterer.

Impact of Sampling Time on Photon Counting Image

Improving the Resolution of Two-Photon Microscopy Using Pixel Reassignment.

Photon Counting Correction Method to Improve the Quality of Reconstructed Images in Single Photon Compressive Imaging Systems.

Sub-nanosecond time resolution detector based on APD for Synchrotron Radiation ultrafast experiments

High Dynamic Range Externally Time-Gated Photon Counting Optical Time-Domain Reflectometry

Acquisition and Application of Energy and Time Information in Large Container Photon-Counting Imaging System

Avalanche Photo-Detection for High Data Rate Applications

Photonic serial implementation of a flash analog-to-digital converter.

64 picosecond time resolved time-correlated single photon counting imaging

Timepix3: single-pixel multi-hit energy-measurement behavior

Ultraviolet photon-counting single-pixel imaging

Free-Running Single-Photon Detection via GHz Gated InGaAs/InP APD for High Time Resolution and Count Rate up to 500 Mcount/s

Development of an optical photon-counting imager with a monolithic Geiger APD array

Passive Inter-Photon Imaging

Photon-timing Detector Module for Single-Molecule Spectroscopy with 60-Ps Resolution

Single photon imaging based on a photon driven sparse sampling

Asynchronous Single-Photon 3D Imaging

Quanta burst photography

Time Correlated Single-Photon Counting (Tcspc) Using Laser Excitation

Characterization on Practical Photon Counting Receiver in Optical Scattering Communication