Abstract:This paper presents a printed circuit board realization of a K-band portable frequency-modulated continuous-wave radar transceiver with beamforming array for short-range localization. The transmitter channel of the proposed radar consists of a free-running voltage-controlled oscillator (VCO) and a single patch antenna. A linear frequency-modulated chirp signal is generated by the VCO, which is controlled by an analog "sawtooth" voltage generator. The receiver channel has a four-element linear beamforming array, a six-port circuit, and a baseband circuit. The beam of the array can be continuously steered in a range of +/- 45 degrees on the H-plane through an array of vector controllers. Each vector controller is capable of simultaneously controlling the phase and the amplitude of the corresponding array element. The design principle of the binary-phase-shift attenuator, the vector controller, and the radar system are discussed. Calibration method of the array is introduced to minimize the errors caused by component variation and fabrication. The radiation patterns of the array with phase-only beam steering and phase-amplitude beamforming are measured and compared, demonstrating the advantage of the beamforming design. System-level experiments showed that the proposed solution is suitable for short-range localization. In addition, experiments with a human subject revealed the capability of the proposed radar system to discriminate a human target from other objects based on the vital-Doppler effect.

Design of a Digital Receiving for LFMCW Active Seeker

Intermediate Frequency Circuit Design for a 60ghz LFMCW Radar

Design of rf front end for cavity beam position monitor based on ics *

Design and Implementation of Micro-Satellite Receiver Using CORDIC Algorithm

A $K$ -Band Portable FMCW Radar with Beamforming Array for Short-Range Localization and Vital-Doppler Targets Discrimination

Design of a Digital IF Signal Processing System for Sinusoid-FM-CW Radar

Design and Realization of Digital Beamforming Technique for Next Generation Phased Array Radar Seeker

A High-Performance Digital IF Receiver and Application in ISAR Imaging

A Signal Processing Practice Method Based on LFMCW Radar

Research on a Digital Channelized IFM Receiver

Design and Implementation of Multichannel Digital RF Receiver

Design and Implementation of a Wideband Digital Reconnaissance Receiver

Design of miniaturized high precision laser azimuth detection system

Design of LFMCW Radar Ranging System and Signal Processing Algorithm

Polyphase Filtering Wide-Band Channelized Digital Receiver

Design of Receiver in Low-altitude Measurement Radar System

A CMOS Analog Integrated Front End for L Band DAB Receiver

Transmitter Leakage Canceling for LFMCW SAR

Design of seeker data acquisition system based on DSP and FPGA

Design of the HF Receiver for the New Type Lonospheric Oblique Backscattering Sounding System

Research on Full Digital Receiver and Realtime Processing of Wideband Digital Array Radar