A digital video decoder with high precision without using a phase locked loop
Xiao Bo,Shen Qing-Hong,Ding Yin-Liang
DOI: https://doi.org/10.3321/j.issn:0469-5097.2009.01.003
2009-01-01
Abstract:At present, whether in the analog or digital video decoder system, the phase locked loop method is used to get the local color subcarrier signal strictly with the same color subcarrier frequency and phase. In the analog video decoder system, to cope with a variety of standard television signals, several crystals with different frequencies, which are switched according to the input signal standard, are controlled by the analog PLL(phase lodced loop) to track the color burst signal. In the digital video decoder system, the crystals are replaced with a NCO(numerically controlled oscillator) with different accumulative steps, which is controlled by the digital PLL to track the color burst signal. Full digital decoder system has a simple structure and the advantage of high precision. But the design of digital PLL is relatively complex, and the sampling frequency should be close to the integral multiple of the color subcarrier frequency, otherwise the phase detector will output a wrong result. The signal that isn't sampled by integral multiple of the color subcarrier frequency should be resampled to get a desired signal before using the digital PLL. For all standard TV signals, the color subcarrier frequency has the relevant specifications. So in some digital video decoder systems, the color subcarrier frequency is set to a fixed value for simplifying the design, and the initial phase of color burst of every line is estimated for decoding the signal. For the broadcast TV signal whose color subcarrier frequency is very accurate, the method has a good result; for the non-standard TV signal, such as VCR(video cassette recorder) signal, whose color subcarrier frequency drifts slightly, this method will affect the picture quality, because the high accurate local color subcarrier is important in guaranteeing the precision of hue of color. This paper presents an all-digital video decoder system under a sample frequency of 50 MHz, which can eliminate the need for a digital PLL, while tracking the color subcarrier frequency drift of a non standard TV signal. In the PAL(phase alternating line) standard system, the length of the color burst signal of a line is about 10～11 cycles, the standard frequency of which is 4.433 618 75 MHz. There are 120 sampling points under the 50 MHz sampling rate. Through the search mechanism, the proper 64 sampling points are obtained to do DFT(discrete fourier transform) transform by multiply accumulator. According to the principle of spectrum correction, the two DFT coefficients are linear interpolated to get the initial phase of the color burst of every line. In the PAL standard, there are about 20 lines of blank level at the beginning of every field, the color burst initial phases of 8 lines of which are unwrapped by phase unwrapping algorithm. The unwrapped phases are used to build the linear regression model by the least square method. The gradient of the unwrapped phases is obtained from the model. Then the estimated value of color subcarrier is computed from the gradient. Both the estimated frequency and the estimated initial phase are used to recover the high accuracy local color subcarrier for chroma demodulation. The raw data is acquired from the PAL standard TV signal generator, from which the picture decoded is presented at the end of this paper.