Abstract:Direct numerical simulations (DNS) of an upward heated pipe flow of supercritical CO2 (at Re0=3600) were carried out with and without conjugate heat transfer (CHT). The aim is to identify the impact of CHT on this specific flow problem and provide information for relevant numerical studies. The configuration is referred to one of the experiments carried out by Luo (2014), with a stainless steel (SS 304) pipe and a thermal activity ratio of 0.061. When CHT is introduced, the predictions of heat transfer coefficient (HTC) and wall temperature obtained in DNS are slightly improved against the experiment measurements. Two primary factors arise when CHT is considered, which are the axial redistribution of wall heat flux and the damping of the enthalpy fluctuations. The former affects the heat transfer particularly within a short distance after the inlet, leading to a more rapid establishment of the thermal boundary layer and a more rapidly progressing ‘laminarising’ process. The latter introduces substantial differences in the fluctuations of enthalpy (∼30 times difference) and density (∼40 times difference), which is however confined within a small region close to the wall and diminishes rapidly further away, resulting in a minor effect on turbulence and heat transfer in the main flow. When CHT is omitted, turbulent kinetic energy is over-predicted up to 1.55 times at most, in particular when the flow is being ‘laminarised’ (z/D<30). This is attributed to the discrepancies in shear production rather than the buoyancy production of the turbulent kinetic energy. Additionally, CHT alters both the laminar (Nul) and turbulent contributions (Nut) to the Nusselt number, with Nul starting at a lower level close to the inlet and the peak of Nut being reduced by 12.3%. These findings provide an insight on the impact of CHT on turbulence and heat transfer at different stages and valuable information for a more accurate modelling method for supercritical fluid flows.

Numerical Simulation of Heat Transfer of Xanthan Gum in Heat Pipe Bioreactor

Numerical Investigation on Hydrodynamics and Heat Transfer of Highly Viscous Fluid in Sulzer Mixer Reactor

Numerical Study on Hydrodynamics, Mixing and Heat Transfer of Highly Viscous Fluid in a Novel Shell-and-tube Heat Exchanger with X-type Baffles

Numerical Investigation of Hydrodynamics and Heat Transfer for Bingham-pseudoplastic Fluids in an Industrial Coiled Stirred Tank

Numerical Simulations of Flow Structure and Heat Transfer in a Central Jet Bubbling Fluidized Bed

Computational Fluid Dynamics Simulations and Experimental Validation of Macromixing and Flow Characteristics in Low-Density Polyethylene Autoclave Reactors

Numerical Study of Heat Transfer Characteristics in Bog Heat Exchanger

Impact of Conjugate Heat Transfer on the Turbulence and Heat Transfer in an Upward Heated Pipe Flow at Supercritical Pressure

Numerical Investigation Of Flow Boiling In A Manifold Microchannel Heat Sink With Conjugate Heat Transfer

Evaluating the efficiency and effectiveness of non-Newtonian fluid flow in a double-pipe heat exchanger with porous medium via numerical simulation

Investigation of boiling heat transfer process in the barrel of a gravity heat pipe type extruder

Numerical investigation into the gas-liquid two-phase flow regime and heat transfer characteristics in a gravity heat pipe

Mass transfer and bubble hydrodynamics in stirred tank with multiple properties fluid via a CFD‐PBM method

NUMERICAL SIMULATION OF ENHANCED CONVECTION HEAT TRANSFER USING METHANE-STEAM REFORMING IN CATALYST FILMS IN A VERTICAL TUBE

Numerical investigation of mixing and heat transfer of granular material in a ribbon reactor: effect of impeller speed and filling rate

CFD simulation based on film model of high temperature potassium heat pipe at different positions: Horizontal, vertical, and 45° inclined

Number simulation of phase-change heat transfer in a gravity heat pipe charged with water

Three-Dimensional Numerical Analysis of Mini-Grooved Flat Heat Pipe Filled with Different Working Fluids with Experimental Validation

Experimental Research on Heat Transfer and Flow Resistance Properties in Spiral Twisted Tube Heat Exchanger

Numerical Study of Heat Transfer on Flow Boiling in Vertical Tube by LB Method Simulation

Research on the Flow Field and Heat Transfer in PVC Suspension Polymerization Reactor