Abstract:Effects of addition of cationic high molecular weight polymers (CP) as a primary flocculant or coagulant aid,,on the treatment efficiencies for raw water with low temperature (T10℃) and low turbidity (C010 NTU) were measured. The raw water was obtained from the Qujiang water treatment plant in Xi′an, China and investigated using a micro-flocculation depth-bed direct filtration process. Fractal mathematics and image analysis were used to analyze the effects of the following factors on treatment efficiencies: filter medium; raw water turbidity and temperature; chemical type, molecular weight and dosage of polymer; and mixing strength. The flocculation mechanism, floc morphologies and the fractal properties of floc structures were also compared after adding different flocculants. Five important results were obtained: ① It is not suitable to use Al2(SO4)3 (AS) or polyaluminium chloride (PAC) alone when T4℃, C04 NTU. Fine sand filter medium should be used if Al2(SO4)3 or PAC is added alone under the conditions 4℃T10℃, C010 NTU. For raw water with low temperature and turbidity, the flocs formed from inorganic coagulants are small, loose and fragile structures, with low efficient mass density and settling rate, but high fractal dimension. ②A coarse sand filter markedly improved CP flocculation efficiencies of raw water with low temperature and turbidity; but the mixing strength should be increased due to high viscosity of CP; ③It is appropriate to use low molecular weight polymers with weakly cationic properties or a lower dosage of CP with strong cationic properties if CP serves as a primary flocculant. When CP is used as a coagulant aid, the dosage of the primary coagulant can be greatly decreased, but it is better to use high molecular weight polymers with strong cationic properties or to increase the dosage of CP with weak cationic properties. ④The flocculation mechanisms of CP are charge neutralization, adsorption and bridging. Flocs formed from CP have have large network configurations, which lead to reduced sludge volumes and increased sludge settling rates as well as good dewatering behavior, but have a lower fractal dimension than inorganic flocs. ⑤ The treatment efficiencies of all tested flocculants are as follows: Al2(SO4)3 (or PAC) +CP CPPAC Al2(SO4)3 .

ENHANCING TREATMENT OF LOW TEMPERATURE AND LOW TURBIDITY WATER WITH A NEW FLOCCULANT WITH POLY-ALUMINUM-FERRIC-SILICATE-CHLORIDE

PREPARATION AND APPLICATION OF POLYMER FERRIC ALUMINUM SULFATE CHLORIDE FLOCCULANT

A New Efficient Flocculant-Preparation and Property of Poly (silicon/aluminum/ferric) Compound

Preparation and Performance Analysis of Inorganic Polymer Flocculant PZFSiC

Flocculation Efficiencies and Morphological Properties of Cationic Polymers in the Treatment of Low Temperature and Low Turbidity Raw Water

Selection of coagulant for treatment of raw water with low temperature and low turbidity from Luanhe River

Comparative Study on the Different Coagulants for Treating Low Temperature,Low Turbidity and High Color Water

Characterization and coagulation–flocculation performance of a composite coagulant: poly-ferric-aluminum-silicate-sulfate

Coagulant Optimization and Effect Research of Low-Temperature and High-Color Source Water Treatment

Application of PAC Modified Active Silica Acid to Treat the Low-Temperature and Low-Turbidity Water

Comparison of Flocculation Processes with Several Kinds of Inorganic Polymeric Flocculants in Water Treatment Plant

Treatment of Low Temperature and Low Turbidity Water by Compound Bioflocculant

Study on Coagulation Property of Metal-Polysilicate Coagulants in Low Turbidity Water Treatment

Preparation and Performance of a High Purity Poly-Aluminum Chloride

STUDY ON PHOSPHORUS REMOVAL OF EFFLUENT FROM MUNICIPAL WASTEWATER TREATMENT PLANT BY POLYALUMINUM FERRIC SULFATE SILICATE

Influence Factors in Treatment of Low Temperature and Low Turbidity Water by Compound Bioflocculant

Optimization of Coagulants in the Treatment of Reservoir Water with Low Temperature and Low Turbidity

Removal of algae from raw water by the combination of modification zeolites and polyaluminum ferric chloride

Study on the preparation of polysilicate ferric flocculant and its treatment of high turbidity tailings water

Treatment of low temperature and low turbidity polluted water by using modified active silica acid

Electroplating Wastewater Treatment by Polyaluminum Ferric Chloride