Abstract:In order to enhance the physical basis of the mass transfer model in numerical simulation of gas-liquid direct contact condensation and improve the fidelity, a set of methods and models are developed. Based on the concept of the piecewise-linear interface calculation (PLIC), an interface reconstruction algorithm is proposed to calculate the interfacial area concentration in three-dimensional non-orthogonal structured grids. The actual interface in the cell is replaced by a plane, whose position is determined iteratively to satisfy the local volume fraction and orientation of the actual interface. The area of the polygonal cut by the plane is taken as the interfacial area in the cell. The proposed algorithm is validated by calculating the surface area of a series of basic geometries. Obvious superiority of the proposed algorithm over the traditional models (gradient model and algebraic model) is seen. Then, the reconstructed area is used to determine the interfacial area concentration in the thermal phase change model. The process is implemented by ANSYS Fluent user-defined functions. The Stefan problem and steam bubble condensation experiment are used to test the performance of the developed methods and models. The simulation results agree well with the theoretical and experimental results with the quantitative relative errors no more than 4.3 % and 15 %, respectively. The oxygen jets condensation experiments are also used as test cases. The primary dominant frequencies predicted by the simulations are 163.01 Hz and 131.65 Hz, which agree well with the 139.72 Hz and 125.75 Hz in the experiments. The relative errors are only 17 % and 4.7 %. The unstable flow pattern of oxygen jet in liquid oxygen crossflow is explained based on the dynamic characteristics of turbulence, heat and mass transfer. The periodic variation of mass transfer rate is considered as the cause of condensation oscillation. The method for calculating the interfacial area proposed in this paper can serve as an optional and practical improvement to the numerical simulation of direct contact condensation.

Effect of capillarity at liquid–vapor interface on phase change without surfactant

The Effect Of Capillary Pressure For Concave Liquid-Vapor Interface On Interfacial Evaporation

Thermodynamic aspect of the shift of concave liquid–vapor interfacial phase equilibrium temperature and its effect on bubble formation

Mechanisms for Enhanced Transition Boiling During Quenching on a Superhydrophilic Surface As Revealed by in Situ Characterization on the Solid-Liquid Contact Using Electrochemical Impedance Technique

Coupling droplets/bubbles with a liquid film for enhancing phase-change heat transfer

The Effect of Interfacial Evaporation on Heat and Mass Transfer of Falling Liquid Film

Droplet Evaporation to Boiling in Van Der Waals Fluid

Role of surfactant-induced Marangoni effects in droplet dynamics on a solid surface in shear flow

Molecular Dynamics Study On Interface Properties And Interphase Transport

MOLECULAR DYNAMICS STUDY ON THE DYNAMIC BEHABIORS AND THERMO- DYNAMIC PROPERTIES OF THE LIQUID-VAPOR INTERFACE

Interfacial Evaporation of Falling Liquid Films with Wall Heating

Development of a modified thermal phase change model based on the interfacial area concentration determined by an interface reconstruction algorithm

Interfacial cooling and heating, temperature discontinuity and inversion in evaporation and condensation

Modified Transition State Theory for Evaporation and Condensation

A new thermal lattice Boltzmann model for liquid-vapor phase change

Blockage of thermocapillary flows by surface-active impurities

Phase transition properties of thin liquid films with various thickness on different wettability surfaces

Theoretical Analysis On Liquid Film Thickness Of Plug Vapor-Liquid Flow With Phase-Change In Horizontal Microtubes

Thermal lattice Boltzmann model for liquid-vapor phase change

Molecular dynamics simulations of the liquid film evaporation heat transfer on different wettability hybrid surfaces at the nanoscale

Effects of the Heating Surface Structure of Phase Change Chamber on Boiling-Condensation Coexisting Phase Change Heat Transfer