Abstract:The anisotropic and irreversible expansion properties of polymer‐bonded explosives (PBX) can significantly influence the utility and reliability of associated equipment. The physical state of PBX under temperature cycling affects the strain distribution across the surface of cylindrical specimens. This strain is indicative of the irreversible growth and anisotropic expansion of the specimens. In this study, fiber Bragg grating sensors are employed to monitor the strain of PBX throughout the temperature cycling process, and our focus was on analyzing the changes in anisotropy and strain distribution during the cycle. The relationships between strain, temperature, material properties, and differences among various materials are examined. Experimental results indicate that the strain along the height and radial directions of the PBX specimens displayed a monotonic gradient distribution, increasing progressively in areas of higher density. TATB‐based PBX exhibited anisotropic expansion throughout the temperature cycling, with the degree of anisotropy increasing during heating and decreasing upon cooling. Conversely, HMX‐based PBX showed greater expansion in the height direction during both the heating and cooling phases, but it did not display noticeable anisotropy following the temperature cycling. At the highest temperature‐holding stage (100°C), the HMX‐based PBX was isotropic. The extent of strain in PBX was correlated with the thermal expansion coefficient of the crystal, although the final degree of expansion was not dependent on the initial range of strain. The ratchet growth of TATB‐based PBX was approximately 31 με greater than that of HMX‐based PBX.

An Experimental Study on Creep Deformation of PBX with Laser Moiré Interferometry Method

An Experimental Study on Creep Behavior of PBX Using Moire Interferometry

On the Propagation and Pulsation of Portevin-Le Chatelier Deformation Bands: an Experimental Study with Digital Speckle Pattern Metrology

Creep Properties Identification of PBX Using Digital Image Correlation

Study on the Relation Between Microstructural Change and Compressive Creep Stress of a PBX Substitute Material

Fracture behavior of PBX simulation subject to combined thermal and mechanical loads

Experimental Study on Dynamic Mechanical Properties of a Mock PBX

Residual thermo-creep deformation of copper interconnects by phase-shifting SEM Moiré method

Strain Measurement on a PBX during Temperature Cycling Using Fibre Bragg Gauges

Creep Behavior and Lifetime Prediction of PMMA Immersed in Liquid Scintillator

Mechanical Behavior of a PBX Substitute Material under Static and Dynamic Loading

Study on Compression–expansion Behaviour of PBXs Substitutive Materials

Experimental Investigation of Polymeric Material Removal by Low Diffraction Laser Beam

Experimental method for creep characterization of polymeric foam materials in media immersion

Experimental Study on the Microstructures and Dynamic Behavior of a PBX Substitute Material

Viscoelastic-Viscoplastic Strength Model for PBX

Experimental Study on the Flexural Creep Behaviors of Pultruded Unidirectional Carbon/Glass Fiber-Reinforced Hybrid Bars

Investigation on the creep mechanism of PA6 films based on quasi point defect theory

Study of creep deformation of metal materials with moire interferometry

Deformation Measurement of Impulsed Viscoelastic Plate with Moire Method

Large deformation and mechanical behavior analysis using temporal speckle pattern interferometry