Abstract:Gas explosion in connected vessels usually leads to high pressure and high rate of pressure increase which the vessels and pipes can not tolerate. Severe human casualties and property losses may occur due to the variation characteristics of gas explosion pressure in connected vessels. To determine gas explosion strength, an experimental testing system for methane and air mixture explosion in a single vessel, in a single vessel connected a pipe and in connected vessels has been set up. The experiment apparatus consisted of two spherical vessels of 350 mm and 600 mm in diameter, three connecting pipes of 89 mm in diameter and 6 m in length. First, the results of gas explosion pressure in a single vessel and connected vessels were compared and analyzed. And then the development of gas explosion, its changing characteristics and relevant influencing factors were analyzed. When gas explosion occurs in a single vessel, the maximum explosion pressure and pressure growth rate with ignition at the center of a spherical vessel are higher than those with ignition on the inner-wall of the vessel. In conclusion, besides ignition source on the inner wall, the ignition source at the center of the vessels must be avoided to reduce the damage level. When the gas mixture is ignited in the large vessel, the maximum explosion pressure and explosion pressure rising rate in the small vessel raise. And the maximum explosion pressure and pressure rising rate in connected vessels are higher than those in the single containment vessel. So whenever possible, some isolation techniques, such as fast-acting valves, rotary valves, etc., might be applied to reduce explosion strength in the integrated system. However, when the gas mixture is ignited in the small vessel, the maximum explosion pressures in the large vessel and in the small vessel both decrease. Moreover, the explosion pressure is lower than that in the single vessel. When gas explosion happens in a single vessel connected to a pipe, the maximum explosion pressure occurs at the end of the pipe if the gas mixture is ignited in the spherical vessel. Therefore, installing a pipe into the system can reduce the maximum explosion pressure, but it also causes the explosion pressure growth rate to increase. (C) 2013 Elsevier Ltd. All rights reserved.

Small scale experiments on boiling liquid expanding vapor explosions: Vessel over-pressure

Mechanism Research Of Boiling Liquid Expanding Vapor Explosion

Two-Phase Expanding Mechanism And Pressure Response Characteristic Of Boiling Liquid Expanding Vapor Explosion Under Rapid Depressurization

Influence of Thermal Stratification by Fire on Heat-Mass Coupling Response Mechanism of the Liquefied Tank

Experimental Research on the Two-Phase Explosive Boiling Mechanism of Superheated Liquid under Different Leakage Conditions

Buffer effects of confined space on the boiling explosion under rapid depressurization

Experimental Investigation And Numerical Simulation Of Gas Explosion In Linked Vessels

Experimental investigation of BLEVE in liquid CO2 phase-transition blasting for enhanced coalbed methane recovery

Study on mechanism and law of liquid overheating and explosive boiling caused by leakage

Experimental investigation on gas explosion and venting in linked vessels

Numerical Investigation on Explosion of Quick Actuating Pressure Vessels Due to Residual Pressure

Numerical simulation of secondary explosion in the external flow field after horizontal explosion venting of a narrow and long vessel

Insight into vented explosion mechanism and premixed flame dynamics in linked vessels: Influence of membrane thickness and blocking rate

Experimental Investigation of Gas Explosion in Single Vessel and Connected Vessels

Investigation on the characteristics of vented stoichiometric methane-air explosion: Effect of ignition positions and obstacles

The overpressure and temperature characteristics of hydrogen-air mixtures during a vented explosion in a large L/D ratio duct: Effect of burst pressure

Experimental study on the flame-dual field overpressure coupling evolution characteristics of LPG/DME blended gas explosion venting

A thermodynamic model for predicting transient pressure evolution in response to venting and vaporization of liquefied gas under sudden release

Experimental study on boiling mechanism of superheated liquid containing ethanol impurity under different leakage conditions

Numerical and experimental study of the explosions caused by residual pressure in quick actuating vessels

An Experimental Study on Steam Explosion of a Small Melt Jet Falling into a Water Pool