Abstract:For energy efficient ventilation and low carbon design, solar chimney has been extensively applied on buildings. In the present work, three representative solar chimneys were introduced, i.e., Model 1 with top-horizontal outlet, Model 2 with upper-vertical outlet and Model 3 with middle-vertical outlet. Updraft ventilation from the built enclosure to the outlet and heat transfer from the absorber to the fluid by heat convection were numerically and theoretically investigated, and their limitations and correlations with governing parameters were also discussed. Streamlines and heatlines were used to visualize transport paths of air and heat respectively. Reverse flow could not be observed in the solar chimney channels of Model 2 and Model 3; Therefore, total volume flow rate induced by the solar chimneys Model 2 and Model 3 and convection heat transfer rate of the absorber increases positively with thermal Rayleigh numbers ( Ra ). Model 2 chimney produces greater thermal buoyancy than that by Model 3, and its air flow rate is higher than that of Model 3. Generally, volume flow rate induced in Model 1 is higher than those of Model 2 and Model 3 as Ra is no more than 2.5 × 10 6 , and simultaneously, convection heat transfer rate Nusselt number ( Nu ) is also greater than those of Model 2 and Model 3. When Ra exceeded 2.5 × 10 6 , reverse air flow was intensified further, Nu of Model 1 started to decline. The three models with discrete heat sources could induce more air from indoor than that respective model without discrete heat sources. The maximum increment rate is obtained by the Model 1 solar chimney with discrete heat sources, then Model 2 and the least done by Model 3. Their power relationships between Nu and Ra , V*and Ra are regressed respectively. The dependence of volume flow rate on broad thermal Rayleigh numbers covering all the three flow regimes showed that there were linear correlations between discrete numerical volume flow rates and the scaling predictions, except in Model 1 for high Ra (exceeding critical value 9.0 × 10 5 ), where volume flow rate was remarkably reduced due to reverse air flow. This research could provide useful theoretical information for applying small sized vertical solar chimneys attached to the building sidewall to effectively reduce built energy consumption.

Enhancement of Natural Ventilation in A Solar House with A Solar Chimney and A Solid Adsorption Cooling Cavity

Achieving standard natural ventilation rate of dwellings in a hot-arid climate using solar chimney

Experimental and Numerical Studies of Solar Chimney for Ventilation in Low Energy

Experimental and Numerical Studies of Solar Chimney for Ventilation in Low Energy Buildings

Solar chimney for a real building considering both energy-saving and fire safety – a case study

Parametric study of a novel combination of solar chimney and radiative cooling cavity for natural ventilation enhancement in residential buildings

Ventilation Performance of Solar Chimney in a Test House: Field Measurement and Validation of Plume Model

A wall solar chimney to ventilate multi-zone buildings

Annual Energy Performance Simulation of Solar Chimney in a Cold Winter and Hot Summer Climate

Theoretical analysis and numerical study of natural convection inside combined solar chimney

Distributed Heat Absorption in a Solar Chimney to Enhance Ventilation

Annual Performance of Solar Chimney for a Multi-Story Building Based on Modelica Multizone Model

Experimental Investigations and Numerical Analysis of Solar Chimney for Building Ventilation

Solar chimney for enhancing thermal comfort in individual housing in a semi-humid climate

Structural and Heat Transfer Model Analysis of Wall-Mounted Solar Chimney Inlets and Outlets in Single-Story Buildings

Experimental investigation of natural ventilation characteristics of a solar chimney coupled with earth-air heat exchanger (SCEAHE) system in summer and winter

Heat removal and ventilation limitations of the solar chimney attached with a built enclosure: Correlations of thermal Rayleigh numbers, port arrangements and discrete heating elements

Analysis of solar chimney ventilation systems in high-rise residential buildings using parallel flow networks

Impacts of storey number of buildings on solar chimney performance: A theoretical and numerical approach

A combined wall and roof solar chimney in one building

Experimental and CFD study of ventilation performance enhanced by roof window and mechanical ventilation system with different design strategies