Abstract:The effects of hole shape and orientation on the mechanical properties of micro-scale 2D honeycomb structures, fabricated using a focused ion beam equipment, have been investigated using an in situ micro-mechanical testing machine inside the scanning electron microscope . The material used was single-crystal Ni oriented in the direction, with the plane of the 2D micro-lattice having a {001} normal direction. The hole shapes explored were hexagonal and circular, while two different orientations of the hexagonal holes were also compared. One of these orientations had a horizontal arm (designated 0° orientation), while the other had a vertical arm (30° orientation) in each hexagon. The results indicate that there is substantial change in strength and ductility depending on the orientation and shape of the holes with respect to the tensile axis. The samples with 30° oriented hexagonal holes had the lowest strength and highest ductility, while the samples with circular holes showed the greatest yield and tensile strength. The samples with the 0° orientated hexagonal holes had much higher strength and lower ductility than the 30° orientated ones. Moreover, the samples with 0° orientated hexagonal holes, which had a similar hole pattern arrangement to the ones with circular holes, had a similar strength to those of the latter type. Thus, it is apparent from this study that the orientation or arrangement of the holes is more important in determining the properties of the 2D microlattice than the shape of the holes. Finite element simulation of the lattice structures utilised the GTN (Gurson, Tvergaard and Needleman) model to evaluate the failure modes under uniaxial tension. The lattice structure has been shown, in a previous paper by the authors, to exhibit composite like behaviour with strength differences in various parts arising from size effects. These size effect variations were incorporated into the model, and a generalised formulation for the GTN parameters was proposed on the basis of one of the experimental configurations and subsequently applied to the other geometries. The models were in good quantitative agreement with the experimental results with accurate representation of the flows stress and failure modes.

The damage tolerance of elastic–brittle, two-dimensional isotropic lattices

A versatile numerical approach for calculating the fracture toughness and R-curves of cellular materials

Fracture Characteristic Analysis of Cellular Lattice Structures under Tensile Load

Fracture of four semi-regular lattices regulated by T -stress in modified boundary layer models

Preliminary Study on Ductile Fracture of Imperfect Lattice Materials

Size-dependency and lattice-discreetness effect on fracture toughness in 2D crystals under antiplanar loading

Mixed-Mode Fracture of Brittle Cellular Materials

Plastic Zone of Semi-Infinite Crack in Planar Kagome and Triangular Lattices

Fracture and Failure Behavior of Additive Manufactured Ti6Al4V Lattice Structures under Compressive Load

Fracture toughness characteristics of additively manufactured Ti–6Al–4V lattices

Fracture toughness of two-dimensional materials dominated by edge energy anisotropy

Analytical Solutions and Numerical Tests of Elastic and Failure Behaviors of Close‐packed Lattice for Brittle Rocks and Crystals

Monte Carlo Simulation of Complex 2D Cohesive Fracture in Random Heterogeneous Quasi-Brittle Materials

Dynamic Fracture Toughness of Cellular Materials with Different Microstructures

Fracture Toughness and Maximum Stress in a Disordered Lattice System

Stress Concentration in Two-Dimensional Lattices with Imperfections

Effects of defects on mechanical behavior of lattice materials

Deformation behaviour of hexagonal- and circular-patterned Ni single-crystal 2D micro-lattices via in situ micro-tensile testing and computational analysis

Toughening Two Dimensional Materials Through Lattice Disorder

Role of crystal lattice structure in predicting fracture toughness