Abstract:Compliance control is required in the applications of robots for assembling, grinding, polishing and human-robot interface, which needs both position control and force control of robots. The impedance control based on joint torque servo is a promising and practical method to realize compliance control in industrial applications. The performance of a joint torque servo controller is thus crucial to the success of compliance control. However, both nonlinear friction torque of the joint motor and varied dynamics of environmental contact during manipulation increase control difficulty greatly. This paper focuses on the compliance control problem and presents a new joint torque servo controller which is a cascading structure including an inner velocity feedback loop and an outer torque control loop. Due to the high signal-to-noise ratio of the motor velocity, an extended state observer is designed to effectively estimate and compensate for the motor friction torque, varied dynamics of environmental contact and other unknown disturbance. And benefiting from the introduction of the efficient and powerful velocity inner loop, the new torque controller performs very well not only in the rigid but also elastic contact environment. Then a standard PD controller is designed in the outer torque loop to produce the control law. Based on the satisfactory joint torque controller, a simplified impedance control algorithm is designed to achieve the force control. Experiments with three other joint torque controllers on a robot manipulator are conducted to demonstrate the proposed joint torque method and the overall force control framework. These results show the proposed joint torque controller can reduce the steady-state error from 3.07 Nm to 0.21 Nm which indicates the joint actuator friction can be eliminated by more than 99%. And a substantial improvement can also be observed in the experiments of force control based on the new joint torque controller.

Position and Force Control of an Inspection Robot with Intersected Tube Welded Seams

Position/Force Control of Robot Based on Passive Compliance

Passive Compliance Control of a Weld Inspection Manipulator for Intersecting Pipes

Robust Force Tracking Impedance Control of an Ultrasonic Motor-actuated End-effector in a Soft Environment.

Hybrid Motion/Force Control of the Hydraulic Cooperative Manipulator in Constrained Motion

Compliance Control for Robot Manipulation in Contact with a Varied Environment Based on a New Joint Torque Controller

Hybrid Force/Position Control Method for Robotic Polishing Based on Passive Compliance Structure

Adaptive Impedance Based Force and Position Control for Pneumatic Compliant System

Design and Simulation Analysis of an Impact-resistant Flexible Joint

Preliminary Study of End-Effector Compliance for Reducing Insertion Force in Automated Fluid Coupling for Trains

Active Compliance Control of a Position-Controlled Industrial Robot for Simulating Space Operations

Dynamic Properties on Double Driving Articulated In-Pipe Robot Inspecting System

On Compliant Force Control Based on Inner Position Loop

Research on Compliance Control for the Single Joint of a Hydraulic Legged Robot.

Compliance Control of Deburring Robots Based on Force Impedance

Synthesis Methods and Experiment Validation of Compliant Force Controller Based Inner Position Loop.

Compliant Coordination Control of Two Moving Industrial Robots

Geometric model-based joint angle selection criterion for force parameter identification & Decoupling control method of position and posture in shaft-hole assembly

A Variable-Stiffness Robot for Force-Sensitive Applications

Force-feedback Based Active Compliant Position Control Strategy for a Hydraulic Quadruped Robot

Analysis and Validation of a Flexible Planar Two Degrees-of-Freedom Parallel Manipulator with Structural Passive Compliance