All Fiber-Optic Sensing of Light Using Side-Polished Fiber Overlaid with Photoresponsive Liquid Crystals

Wei-Huan Fu,Vincent K. S. Hsiao,Jie-Yuan Tang,Ming-Hung Wu,Zhe Chen

DOI: https://doi.org/10.1016/j.snb.2011.04.073

2011-01-01

Abstract:This study presents a highly sensitive, all-fiber sensor for in situ detecting light. A fiber-optic light sensing platform was created by overlaying an in-line side-polished fiber (SPF) with a photoresponsive liquid crystal (P-LC) consisting of an azobenzene dye, a chiral dopant, and a nematic LC. The resulting P-LC overlaid SPF light sensor is sensitive to three different light sources, including 380nm light emitting diode (LED), mercury lamp, and office ceiling lights. Under the light illumination, the energy of irradiation from short wavelengths of light (<450nm) initiates the trans-to-cis photoisomerization of azobenzene. The photochemical LC-phase transition induced by the generated cis-moiety of azobenzene changes the refractive index of LC-overlaid side-polished area. Light illumination increased the attenuation of the input laser signal. After turning off the illumination, the attenuation returned to its original value, allowing the fiber-optic light sensor to be reused. The sensitivity of the resulting fiber-optic light sensor was 0.16dB/(μW/cm2) with a detection limit of 5μW/cm2 and 0.06dB/lx with a detection limit of 45lx when a 380nm LED and office ceiling lights were used as illumination sources, respectively. The detection limit increased from 45 to 12lx when P-LC containing 20wt% azobenzene was used as light sensing material. The proposed fiber-based light sensor has potential use in harsh environments, such as severely humid and corrosive environments, which could damage mechanical and electronic light sensors.