Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Three-dimensional CFD Simulation of Bubble–melt Two-Phase Flow with Air Injecting and Melt Stirring

Computational Fluid Dynamics Simulation of Bubble Size and Local Gas Holdup in Stirred Vessel

Numerical Simulations Of Fluid Dynamics And Mixing In A Large Shallow Bubble Column: Effects Of The Sparging Pipe Allocations For Multiple-Pipe Gas Distributors

Numerical Simulation on Gas-liquid Flow in Mechanical-Gas Injection Coupled Stirred System

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Effect of Orifice Geometry on Bubble Formation in Melt Gas Injection to Prepare Aluminum Foams

Motion and mass transfer models for single bubble in an aluminum melt under a compound field of ultrasonic and rotating flow

Experimental and Numerical Study on Flow Resistance and Bubble Transport in a Helical Static Mixer

Experimental Investigation on Submerged Gas-Liquid Mixture Injection into Water Through A Micro-Channel

Numerical Simulation of Multiphase Flow in Steel Continuous Casting Mold Using a Novel Euler–Euler–Lagrange Method

Bubble Formation at a Submerged Orifice for Aluminum Foams Produced by Gas Injection Method

Numerical simulation study of the effect of nonlinear side blowing on the flow of gas-liquid two-phase flow

Numerical Simulation of Solid-Liquid Mixing Characteristics in a Stirred Tank with Fractal Impellers

Large Eddy Simulation on the Two‐Phase Flow in a Water Model of Continuous Casting Strand with Gas Injection

CFD–PBM Simulation on Bubble Size Distribution in a Gas–Liquid–Solid Flow Three-Phase Flow Stirred Tank

CFD modeling of hydrodynamic characteristics of a gas-liquid two-phase stirred tank

Experimental Study and Numerical Simulation of Gas–Liquid Two-Phase Flow in Aeration Tank Based on CFD-PBM Coupled Model

Fluid Property Adjustment of Water-Ethanol Mixture for the Application of Metal Foam Production

Numerical investigation of bubble behavior and multiphase flow in ladle using purging plug with inclined slit designs

Numerical simulation of coupled fluid flow and solidification in a curved round bloom continuous caster with a combined rotary electromagnetic stirring

Analysis of Flow Pattern and Bubble Behavior in Slab Continuous Casting with Mold Electromagnetic Stirring