Abstract:Topology optimization has been extensively utilized to generate cold plates with efficient cooling performance. However, the design of composite cold plates remains challenging. This study presents a two-solid topology optimization method for conjugate heat transfer based on ordered SIMP (solid isotropic material with penalization). The proposed method aims to develop high-performance composite cold plates by leveraging the differences in thermal conductivity of various materials. The optimization results were investigated for four inlet and outlet combinations at various Reynolds numbers. The results indicate that using a staggered distribution of multiple inlets and outlets yields higher heat transfer than a single distribution. Furthermore, composite cold plates derived from the two-dimensional optimized models were numerically compared with rectangular flow channel and non-composite cold plates. The optimized channels exhibited superior hydrothermal performance over the rectangular flow channel, which was primarily attributed to the weakening of the velocity stagnation region. The average temperature ( T ̄ ) and root mean square temperature ( RMST ) of the heat source were reduced by a maximum of 2.53% and 57.67%, respectively. The friction factor decreased by up to 50.42%. Compared to non-composite cold plates, the decrease in RMST reached 16.24% without any additional increase in the pumping power. Composite cold plates further promote temperature uniformity by accelerating the heat transfer rate through their high thermal conductivity, thereby mitigating the occurrence of hotspots. Finally, the performance of the three test samples was experimentally compared to validate the numerical results. The optimized design enables the strategic allocation of highly thermally conductive material on a cold plate while employing more cost-effective alternatives in other areas. The proposed method is anticipated to expand the design possibilities for cold plates and provide insights into addressing concerns related to hotspots in equipment.

Analysis of Heat Transfer Behaviour of the Conduction Cold Plate System

Experiments and numerical simulation of dynamic cool-down process of stainless steel plate in liquid nitrogen bath

Numerical Analysis of Heat Transfer Characteristics of a Falling Film Type Plate-Fin Condenser/Reboiler

Thermal Design For High Density Avionics Package

Cold plate performance enhancement based on parametric modeling of multiple structures

Evaluation of Heat Conduction and Visualization of Heat Flux in a Plate Making Use of Heat Transfer Experiments

Study on heat transfer performance of cold plate with grid channel

A Comparative Numerical Analysis of Cold Plates for Thermal Management of Chips With Hotspots

Experimental and numerical study of the effect of conjugate heat transfer on film cooling

Influence Analysis of Convective Heat Transfer of Circular Tubes and Flat Plates in a Polar Environment

Effects of vibration conditions on the heat transfer and flow characteristics of cold plates

Analysis of Cold/Hot Spot Effect in Flight Test Heat Flux Measurement

Semianalytical Research on Aerothermoelastic Behaviors of Functionally Graded Plates under Arbitrary Temperature Fields in Hypersonic Vehicles

Thermal design of composite cold plates by topology optimization

Experimental and Numerical Investigation of Conjugate Heat Transfer to a High Temperature Flat Plate with Film Cooling

Conjugate Heat Transfer Modeling of a Cold Plate Design for Hybrid-Cooled Data Centers

Performance analysis and design optimization of avionics devices with single-phase submerged jet cooling

Effects of sinusoidal wall temperature on thermal dynamics and irreversibility around an inclined plate embedded in a square cavity

3-D Steady Temperature Field in a Laminated Rectangular Plate

A Temperature Field Model of Complicated Thermal Analysis System Based on Thermal Network Method

Conjugate Heat Transfer Investigation of Trenched Film Cooling Characteristics