Abstract:This work deals with the characteristics of LM-13alloy under cyclic stress with and without 63% by weight of SiC-reinforced composite particle reinforcements both cast and tempered at ambient condition. The hardness of the composite sample before and after tempering was 112 HV and 134HV. The tempered sample shows 16.4% increment. UTS of base alloy and the composite was determined to be 165 MPa and 149 and 210, and 145 and 192, respectively. The UTS decreases by 12% in cast state and 8% in tempered condition. The tempered base alloy shows an increment of 21%, and the 0.25% proof stress increased by 28%. After heat treatment, the elongation at the break of the base alloy improved to 3.5%. The tempered specimen shows an increased fatigue performance of approximately 43%. The fatigue life was determined to be about 165 repetitions at the 75 MPa level of stress with 75% of UTS utilization. Decohesion of a silicon particulate interaction and in certain circumstances, the subsequent breakdown of SiC particles has led to fractures in composites. The preheated eutectic silicon that had an almost gain round shape will withstand crack growth development, as the aluminum matrix had a higher cohesive force compared to reinforced SiC particles which provide less strain increase locations. Stronger bonds among silica eutectic and aluminum matrices produced the fracture across their contact, silicon breaks owing to the application of the fatigue load and lead to specimen failure.

The Dynamic Mechanical Response of Sic Particulate Reinforced 2024 Aluminum Matrix Composites

The Compressive Properties of 2024al Matrix Composites Reinforced with High Content SiC Particles at Various Strain Rates

Dynamic compressive properties of 40 vol%SiC_P/2024Al composite

Experimental Study Of The Rate-Sensitivity Of Sicp/Al Composites And The Establishment Of A Dynamic Constitutive Equation

EXPERIMENTAL STUDY ON DYNAMIC COMPRESSION PROPERTIES OF SiCp/2024Al PARTICLES-REINFOCED METAL MATRIX COMPOSITES

The dynamic properties of SiCp/Al composites fabricated by spark plasma sintering with powders prepared by mechanical alloying process

The dynamic mechanical response of Al2O3 and TiB2 particulate reinforced aluminum matrix composites produced by in-situ reaction

Effect of Strain Rate on Tensile Behavior of SiCp/AI MMC

Microstructure-based Modeling and Evaluation of Dynamic Behaviors of SiCp/2024Al Composites①

Deformation and damage mechanisms of SiC/Al matrix composite under high compressive stain

Hot Deformation Behavior of SiCw/AZ91 Magnesium Matrix Composite in Compression

Dynamic deformation behavior of a high reinforcement content TiB2/Al composite at high strain rates

High strain rate superplasticity in SiCw/2024Al composite made by squeeze casting

Hot Deformation Behavior and Mechanisms of SiC Particle Reinforced Al-Zn-Mg-Cu Alloy Matrix Composites

Mechanical Properties of A359/SiCp Metal Matrix Composites at Wide Range of Strain Rates

Mechanical Test on Aluminum Alloy with Maximal Soluble SiC Reinforcement

Investigation of Compression of Sicw/6061al Composites Around the Solidus of the Matrix Alloy

Influence of strain rate and temperature on the compressive deformation of a eutectic Al-Si alloy based composite reinforced with -Si3N 4 whisker

Deformability of a SiCw/6061Al composite during high strain rate compression at elevated temperatures

Microstructure-Based Modeling of the Dynamic Behaviors of SiCp/7075Al Composites

Hot Deformation Behavior of Sicp/Az91 Magnesium Matrix Composite Fabricated by Stir Casting