Abstract:This paper reports an experimental investigation on the bending behavior of cold-formed continuous Z-purlins with lapped connections. The first part of the tests was performed on the load-carrying capacity of the lapped segments. The specimens are simply supported beams with cantilevers of the same span length, and concentrated loads applied at the free ends of the cantilevers. The lapped lengths are changed from 3 to 5.625 times the depth of the Z-section. A part of the specimens have self-tapping screws in both flanges, while the others have them only in the top flanges. A total of 30 specimens were tested for the ultimate bending moment of lapped segments. It was found that most of the specimen failed due to buckling of the compressed flange. The failure occurs at the start section of lap. When the bending moment at the support is double that at the start of the lap, then failure appears at the support. The lapped lengths of the connections do not affect the load-carrying capacities of tested specimens, but the connections with self-tapping screws in both flanges can carry 5% more loads than those with self-tapping screw only in the top flanges. The second part of the test was done on the bending stiffness of the lapped segment and two-span continuous beams were tested. The lapped lengths are 10% and 20% of a single span length respectively, again part of specimens have screws in both flanges and the others have screws only in the top flange. 11 specimens were tested in total. It was shown that the lapped length influences the stiffness of the lapped segment. Based on the test, the bending stiffness for moment analysis and the deflection calculation are suggested.

NOTIONAL LOAD ON BOTTOM FLANGE IN STRENGTH CALCULATION OF Z-SHAPED CROSS SECTION PURLIN

Lateral Buckling of Simply Supported C- and Z-Section Purlins with Top Flange Horizontally Restrained

ANALYSIS OF TWISTING ABOUT UPPER FLANGE OF C-SECTION PURLIN WITH TWO SAG RODS

ELASTIC FLEXURAL-TORSIONAL BUCKLING OF C-PURLIN AND Z-PURLIN

Stress analysis on cold-formed C-purlins subjected to wind suction load considering the effective stiffness of anti-sag bar

INTERNAL FORCE ANALYSIS OF CONTINUOUS Z-SHAPE PURLIN WITH ANTI-SAG BARS

BENDING AND TWISTING ABOUT A CONSTRAINED AXIS OF Z-SECTION PURLINS WITH ONE SAG ROD AT MIDSPAN

BENDING AND TWISTING ABOUT A CONSTRAINED AXIS OF C-SECTION PURLINS WITH ONE SAG ROD AT MIDSPAN

ANALYSIS OF GLOBAL STABILITY OF C-PURLINS UNDER WIND SUCTION

Moment Resistance and Flexural Rigidity of Lapped Connections in Multi-Span Cold-Formed Z Purlin Systems

Distortional and Lateral Buckling of Z-Purlins with Sloping Lips in Flexure

LATERAL-TORSIONAL BUCKLING OF C-SECTION COLD-FORMED PURLINS WITH TWO ANTI-SAG BARS

TORSIONAL RESTRAINT OF CONCEALED-FASTENER ROOF SYSTEM TO PURLINS AND THE INFLUENCE

NOTIONAL LOAD APPROACH FOR FLEXURAL BRACING-FRAME

A unified analysis for distortional and lateral buckling of C-purlins in flexure

Experimental Investigation on Nested Continuous Z-purlins under Gravity Loading

Lateral Buckling of C-section Purlins with One Anti-Sag Bar at Middle Span Section

LATERAL-TORSIONAL BUCKLING OF TWO-SPAN CONTINUOUS C-SECTION PURLINS WITH ONE ANTI-SAG BAR AT MIDDLE SPAN SECTION UNDER WIND SUCTION

A UNIFIED ANALYSIS METHOD FOR DISTORTIONAL AND GLOBAL BUCKLING OF Z-PURLINS IN FLEXURE

Buckling of Parallel Purlins Inter-Braced by Sag-Rods

Notional load approach for shear-type braced frames