Abstract:The Navy Prototype Optical Interferometer (NPOI) array, located near Flagstaff, Arizona, transports 12.5 cm diameter stellar radiation simultaneously from six primary collectors through a 9,000 cubic foot vacuum relay system prior to entering a specialized laboratory where further manipulations of each beam occur. The relay system redirects each 12.5 cm beam 10 times. Ground-based optical interferometry requires very high quality, ideally flat, relay mirrors. The mirrors used in the relay system have flatness deviation tolerance 32 nm peak-to-valley over the 18.3 cm clear aperture. Once mounted in the 10-element optical train, errors from each mirror tend to stack up and increase the resultant wavefront distortion for that path. This leads to reduced fringe contrast, fringe tracking, and number of observables. In a previous paper, it was shown that it is possible to mitigate the resultant wavefront distortion by using a phase-shifting interferometer combined with a single compliant static deformable mirror and control system. In that work, the mirrors tested showed a fairly uniform, concentric concavity deformation, which a single, centrally located actuator may significantly improve. In this paper, we extend the previous analysis to consider an off-center actuator acting on a mirror to counteract an asymmetric wavefront distortion resulting from the superposition of several relay mirrors. The shape applied to a single corrector mirror was determined from the resultant wavefront distortion of a 7-reflection optical relay system using phase-shifting interferometer data. Finite element analysis results indicating how resultant wavefront error from a collection of slightly deformed mirrors can be cancelled are presented and discussed.

Methods for the Characterization of Deformable Membrane Mirrors

Interferometry Measurement Of Parallel Optical Plate Wavefront

Membrane based Deformable Mirror: Intrinsic aberrations and alignment issues

Research of an Adaptive Micro-Mirror Based on Micro-Opto-Electro-Mechanical- System

Research on PZT-based Deformable Micro-mirror Array in Adaptive Optics

Mirror-mode sensing with a holographic modal wavefront sensor

Simulative and Experimental Characterization of an Adaptive Astigmatic Membrane Mirror

Development of A Novel Three-Dimensional Deformable Mirror with Removable Influence Functions for High Precision Wavefront Correction in Adaptive Optics System

Analysis of A Compliant Static Deformable Mirror for Wavefront Error Cancellation

Wavefront Calibration and Correction of an Optical Train Path: a Compliant Static Deformable Mirror Approach

Deflectometry based calibration of a deformable mirror for aberration correction and remote focusing in microscopy

A Support Structure for A Compliant Deformable Mirror

High-precision system identification method for a deformable mirror in wavefront control.

Adaptive System for Ocular Wavefront Analysis With Subjective Refinement

Study of a Novel Deformable Mirror for Adaptive Optics Used in Satellite

Active optics: deformable mirrors with a minimum number of actuators

Wavefront Correction Performed by a Deformable Mirror of Arbitrary Actuator Pattern Within a Multireflection Waveguide.

Experiments on Quasi-Static and Dynamic Control of a PVDF Laminated Membrane-Like Mirror

A Study on Deformable Mirrors Control and Error Analysis

Optical calibration of large format adaptive mirrors

Structure and Closed-Loop Control of A Novel Compact Deformable Mirror for Wavefront Correction in A High Power Laser System