Abstract:Power saving has always been an important research direction in the field of microcontrollers. Dozens of low power technologies have been proposed to achieve the goal of reducing their power consumption. However, most of them focus mostly on lowering the consumption rate. It is well known that energy is the integral of power over time. Thus, our view is that both power and time should be carefully considered to achieve better energy efficiency. We reviewed some commonly used low power technologies and proposed our assumptions and strategy for improving energy efficiency. A series of test sets are designed to validate our hypotheses for improving energy efficiency. The experimental results suggest that time has no less impact on energy consumption than power. To support the operation of the processor, some peripheral components consume a constant amount of power regardless of the clock frequency, but the power consumption will be reduced when the processor enters low-power modes. This results in some interesting phenomena that are different from the usual thinking that energy can be saved by increasing processor clock frequency. For STM32F407 and Xtensa LX6 processors, this article also analyzes and calculates the minimum sleep time required for achieving energy saving based on our analytical models. Our energy efficiency strategy has been verified, and in some cases, it can indeed improve energy efficiency. We also proposed some suggestions on hardware design and software development for better energy efficiency.

Design and Implementation of Eight-bit High Performance and Low Power MCU

Design and Implementation of High-Efficiency and Low-Power DC-DC Converter with PWM/PFM Modes

An Effective BIST Circuit for Barrel Shifter Within 8 Bits MCU

Architecture Design of an Asynchronous Low Power Microcontroller and Its VLSI Implementation

Design of a Novel 8-Bit 0.35-&Amp;#x00b5;m BiCMOS Pipelined ADC

Research on low power technology based on Multi Bit Flip Flop

Design of low-power and high-speed multiplier

Ultralow Power Processor Employing Block Instruction for ECG Applications

Low Power Design of Portable ECG Monitor Using C8051F040 Microcontroller

Asynchronous Pipeline Micro-Control-Unit (mcu) Chip Design

Towards ultra low-power MCU implementation through physical design based on improved multibit SRPG

Design and Implementation of 16-bit RISC MCU for Medical Electronics Applications

Low Power Pipelined A/D Converter in 0.6 Μm Technology

An Energy-Efficient Strategy for Microcontrollers

Gate Oxide and Implantation Process Co-Optimization for Low-Power MCU Applications

Design Methodology Of Cmos Low Power

Design of Low Power Consumption Controller Applied to Implantable Medical Device

Power reduction through specific instruction scheduling based on hardware/software Co-design

Design of a Low-Power and Low-Area 8-Bit Flash ADC Using a Double-Tail Comparator on 180 nm CMOS Process

Low-power SoC design and system implementation for medical applications

Implementation of Low Power Strategies in a Base-band Chip in 40nm CMOS Technologies