Abstract:It has long been known that hydrogen impurities can be incorporated in the structure of nominally anhydrous minerals (NAMs) and substantially influence their physical properties. One of the geologically most prominent NAMs is feldspar. The hydrogen concentration in NAMs is usually expressed in parts per million of water by weight (ppm H2O wt.) In this paper, we use the term “hydrogen” for uniformity, except when we use “water” for describing its amount expressed as parts per million of H2O by weight. In our article (Liu et al., 2018), we carried out in situ high-temperature X-ray powder diffraction and Raman spectroscopic studies on three natural anorthoclase samples with similar Or (K-feldspar) contents (Ab67Or31An2, Ab66Or31An2, and Ab65Or33An3) and Al–Si disordering but contrasting water contents. The spectroscopic results suggested that the displacive phase transition temperature is higher for the nearly anhydrous anorthoclase sample than the anorthoclase samples with about 200 ppm water, and we thus concluded that hydrogen is another factor impacting the displacive phase transition temperature. We thank Kroll and Schmid-Beurmann for pointing out the weakness in our interpretation that hydrogen is a possible important factor (Kroll and Schmid-Beurmann, 2020). To clarify this issue, we conducted transmission electron microscopy (TEM) experiments on the three samples to check texture effects. The TEM studies indicated that the nearly anhydrous anorthoclase sample consists of two feldspar phases, a K-poor and a K-rich one, and that the K-poor area may be responsible for the higher displacive phase transition temperature. According to the observation that the temperature of redistribution of hydrogen is accordant with the displacive phase transition temperature, the effect of hydrogen could not be ruled out. Based on these results, it can be concluded that hydrogen may not be the sole possible factor, and it was a proposition more than a definitive proof for the moment. Natural feldspars are complex, and factors affecting displacive phase transitions are multiple (e.g., Salje et al., 1991; Harrison and Salje, 1994; Hayward and Salje, 1996; Dobrovolsky et al., 2017). Therefore, to further investigate hydrogen effects on displacive phase transition in feldspar, synthetic samples with pure chemical compositions and hydrogen species are necessary. In the following, we address each issue in the same order as in the comment by Kroll and Schmidt-Beurmann (2020).

The Influence of Random Defect Density on the Thermal Stability of Kaolinites

Molecular Dynamics Simulation of Deformation and Failure Mechanism of Kaolinite at Different Temperatures

Deformation and Failure Processes of Kaolinite under Tension:Insights from Molecular Dynamics Simulations

A Molecular Dynamics Study of the Mechanical Properties of Kaolinite under Uniaxial and Isothermal Compression at Various Temperatures

Defect and temperature effects on the mechanical properties of kaolinite: a molecular dynamics study

A Molecular Dynamics Study on the Structural and Mechanical Properties of Hydrated Kaolinite System under Tension

A Molecular Dynamics Study on the Structural and Mechanical Properties of Pyrophyllite and M-Montmorillonites (M = Na, K, Ca, and Ba)

Investigating Temperature Effects on the Shear Behavior of Clays: Molecular Dynamics Simulations

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Analysis of the microstructure and morphology of disordered kaolinite based on the particle size distribution

Effects of Different Potassium Salts on the Formation of Mullite As the Only Crystal Phase in Kaolinite

Reply to Kroll and Schmid-Beurmann's Comment on &amp;#8220;water Decreases Displacive Phase Transition Temperature in Alkali Feldspar&amp;#8221; by Liu Et Al. (2018)

INTERACTIONS OF KAOLIN WITH HEAVY METALS

Effects of residual alkali metals on the hydrothermal/thermal stability of silicalite-1

Si-29 and Al-27 Mas Nmr Spectra of Mullites from Different Kaolinites

Experimental Study of the Stability and Phase Relations of Clays at High Temperature in a Thermal Gradient

Size-driven phase transformation and microstructure evolution of ZrO2 nanocrystallites associated with thermal treatments

Nanoscale mechanical behavior of kaolinite under uniaxial strain conditions

Investigating the Influence of Impurity Defects on the Adsorption Behavior of Hydrated Sc3+ on the Kaolinite (001) Surface Using Density Functional Theory

Transitions in the thermal stability of pre-strained austenite – competing effects between defect density and slip band spacing

Probing the Dehydroxylation of Kaolinite and Halloysite by In Situ High Temperature X-ray Diffraction