Abstract:Due to the advantageous characteristics of laser welding technology, it is being increasingly used for constructing stainless steel rail vehicles. It can improve the appearance of a vehicle, enable designs with a relatively high degree of flatness, and ensure higher-quality connections between different parts of a vehicle. Moreover, it can improve the strength and stiffness of the components of the vehicle. In this study, a large-scale assembly module of a stainless steel side-wall was considered as the research object. The combined heat source model of a Gaussian heat source and a cylindrical volume heat source was used to obtain the heat source parameters of laser welding to match the experimental data. Based on the thermal cycle curve method (TCCM), the influence of the number of weld segments and mesh divisions of the local model on the efficiency and accuracy of laser welding simulations was investigated. Thereafter, the research results were applied to the welding simulation of the whole side-wall module. The shape of the molten pool obtained using the combined heat source was closer to that of the experiments (error < 10%), demonstrating the accuracy and effectiveness of the developed the heat source model for laser welding simulation. For local model laser welding using the TCCM, a coarse mesh was used, and the weld was divided into four segments, and highly accurate results were obtained. This calculation time was only 5.97% of that of a moving heat source in case of the thermo-elastic-plastic method (TEPM). Residual stress and welding deformation of the stainless steel side-wall module were calculated according to actual process parameters and the results of local model simulation. Residual stress was discontinuously distributed at the weld segments, and it only slightly influenced the overall stress distribution. The maximum residual stress (462.15 MPa) occurred at the weld of the large crossbeam. Welding eight small and two large crossbeams influenced the deformation change and the maximum deformation (1.26 mm) appeared in the middle position of the left side-wall. The findings of this study show that the TCCM has high calculation accuracy and is sufficiently economical for predicting laser welding of large structures.

Research on the process of laser automated welding part with spatial surface

Three-dimensional laser welding of the anti-explosion loop

Laser welding simulation of large-scale assembly module of stainless steel side-wall

Applying Statistical Models Optimize the Process of Multi-Pass Narrow-Gap Laser Welding with Filler Wire

An Experimental Study on Spot Shape Based on Galvanometer Scanning Laser Spot Welding

Process Stability and Parameters Optimization of Narrow-Gap Laser Vertical Welding with Hot Wire for Thick Stainless Steel in Nuclear Power Plant

Optimization for Laser Welding Fillet Joint Based on Response Surface Method

The Research on System of Fiber Laser Welding Body-in-white Based on Flexible Robot

Laser Beam Welding Technique of Large Thin-walled Components with In-site Press and Automatic Focus Tracking

3D reconstruction of complex spatial weld seam for autonomous welding by laser structured light scanning

Research on the Technology of Laser Welding in Senor Shell of Stainless Steel

Optimization of laser welding thin-gage galvanized steel via response surface methodology

Quality improvement of copper welds by laser microwelding with the usage of spatial power modulation

Study on Improving Surface Quality of Weld of Autogenously Laser Welding of Thick Plate with High Power Fiber Laser

Investigation of Laser Welding on Vehicle Safety Parts

Present situation and future trend of laser welding technique

Mechanisms For Improvement Of Weld Appearance In Autogenous Fiber Laser Welding Of Thick Stainless Steels

Effect of process parameters on interface microstructure and performance in laser welding of steel-ZrO2 ceramic

Autonomous Programming and Adaptive Filling of Lap Joint Based on Three-Dimensional Welding-Seam Model by Laser Scanning

A study of welding process in connecting borosilicate glass by picosecond laser pulses based on response surface methodology

Research on Welding Quality Optimization of Ultra-High Strength Steel Welding Joint Under Different Laser Energy Inputs