Abstract:This article is based on the application of a staggered tube bundle anti-icing structure in the air intake ducts of naval vessels. It introduces a fin-staggered tube anti-icing structure designed to enhance the performance of the air intake anti-icing device. The primary performance indicators for the anti-icing device on ships include pressure loss and temperature increase. Friction factor (f) is employed to measure the extent of pressure loss, while the Colburn factor (j) is used to assess heat transfer efficiency, both serving as performance metrics for the structure in this study. Numerical simulations were conducted to calculate f and j within the same velocity range and characteristic scale. Using j/f (1/3) as the standard for calculating comprehensive heat transfer performance (ξ), the ξ0 and ξ were determined for both the staggered tube anti-icing structure and the fin-staggered tube anti-icing structure. The results indicate that when the inlet velocity exceeds 9.2 m/s, the value of ξ/ξ0 is greater than 1, suggesting that the fin-staggered tube anti-icing structure outperforms the prototype staggered tube anti-icing structure in comprehensive heat transfer performance. Through numerical simulations, calculations were performed for the inlet and outlet total pressure loss (ΔP) and inlet and outlet temperature increase (ΔT) of the anti-icing structure under various conditions, including a heat source temperature of 430 K, H n ranging from 16 mm to 18 mm, and S 1 /S 2 ranging from 0.7 to 1.2. This was used to calculate values of f, j, and ξ for different S 1 /S 2 ratios. The calculation results indicate that there exists a specific S 1 /S 2 value at which the ξ of the fin-staggered tube anti-icing structure reaches its peak. The ξ of the selected structure in this paper peaks at an S 1 /S 2 value of 0.85. The calculation method presented in this paper provides valuable reference for the design of air intake heating structures for marine intakes.

Numerical Simulation and Structure Optimization of the Ship Air Intake System

Numerical Simulation and Structure Optimization of Compressor Muffler

Numerical Study of Hydrodynamic Performance of A High Maneuverability Ocean Engineering Ship with Pod Propeller Design

Numerical Investigation on the Cavity Behavior and Hydrodynamic Performance of a Planing Air Cavity Ship

Numerical simulation study on the resistance and heat transfer performance of anti-icing device of fin-staggered tube structure in marine intake system

A Numerical Study on the Resistance Prediction of a Medium Speed Craft

Preliminary Numerical Investigation of Effect of Interceptor on Ship Resistance

Numerical computed methods for intake manifolds in gasoline engine

Numerical Simulation of Viscous Flow Around High Speed Monohull and Trimaran Ships

Ship Optimization Based on Fully-Parametric Models for Hull, Propeller and Rudder

Structure Optimization of Natural Gas Engine’s Intake Pipe Based on One-Dimensional and Three-Dimensional Coupled Simulation

Flow Field Analysis of Ship Exhaust System Based on CFD

Multi-objective Optimization of the Flush-Type Intake Duct for a Waterjet Propulsion System

Numerical simulation of air ventilation and its suppression on inclined surface-piercing hydrofoils

Numerical Study on the Influence of Interceptor and Stern Flap on Ship Resistance and Motion Response in Regular Waves

Investigation on Some Factors Effecting Ship Resistance Calculation with CFD Code FLUENT

Simulation analysis of underwater working condition of ship rudder blade based on Fluent

Numerical Investigation on a High-Speed Transom Stern Ship Advancing in Shallow Water

Optimal Design of Inlet Passage for Waterjet Propulsion System Based on Flow and Geometric Parameters

A CALCULATION METHOD OF NUMERICAL SOLUTION OF REYNOLDS-AVERAGED NAVIER-STOKES EQUATIONS FOR SHIP STERN FLOW

Study on Optimization Simulation of Scr Denitration System for Marine Diesel Engine