Abstract:The highly filled isotropic polyurethane (PU) elastomer with a magnetorheological (MR) effect was prepared through an in situ polycondensation method. The carbonyl iron particles were treated by coupling agents and then the dispersions of polyol/carbonyl iron particles was prepared by a ball milling process. The dispersion problem of magnetizable particles at a high content in PU matrix was tried to overcome by the combination of surface modification, ball milling, and in situ polymerization. The microstructure and properties of the composite were examined in detail. With increasing the content of carbonyl iron particles, the degree of phase separation of PU increased and the glass transition temperature (T-g) of PU soft segment decreased. Highly filled carbonyl iron particles led to the decrease in the thermal stability of PU matrix, especially in the heating air atmosphere. The MR effect appeared when the content of carbonyl iron particles was higher than 50 wt %, and became relatively pronounced at a 70 wt % of carbonyl iron content. The mechanical properties of PU MR elastomers were deteriorated significantly at a high content of carbonyl iron. Surface modification of carbonyl iron particles can improve the mechanical properties to some extent; however, it was also found that surface modification led to a decrease in the MR effect because of the improved interfacial adhesion. The MR test showed that the maximum absolute MR effect and relative MR effect of PU composite were similar to 0.31 MPa and similar to 8.1% at 1 Hz and 400 mT with 70 wt % of carbonyl iron, respectively. (C) 2009 Wiley Periodicals, Inc. J Appl Polym Sci 114: 901-910, 2009

New magnetorheological elastomers based on polyurethane/Si-rubber hybrid

MAGNETORHEOLOGICAL ELASTOMERS BASED ON POLYURETHANE/<font>SI</font>-RUBBER HYBRID

Preparation and Properties of Magnetorheological Elastomers Based on Silicon Rubber/polystyrene Blend Matrix

Preparation and characterization of isotropic polyurethane magnetorheological elastomer through in situ polymerization

Effects of rubber/magnetic particle interactions on the performance of magnetorheological elastomers

Anisotropic polyurethane magnetorheological elastomer prepared through in situ polycondensation under a magnetic field

Research on Magnetorheological Elastomer Based on Silicone Rubber

Magnetorheological Elastomers Based on Isobutylene- Isoprene Rubber

Influence of Polyurethane Properties on Mechanical Performances of Magnetorheological Elastomers

Study on the properties of magnetorheological gel based on polyurethane

The study of natural rubber/polybutadiene rubber hybrid matrix-based magnetorheological elastomer

Investigation on magnetorheological elastomers based on natural rubber

A high-performance magnetorheological material: Preparation, characterization and magnetic-mechanic coupling properties

Stretchable Polyurethane Sponge Reinforced Magnetorheological Material with Enhanced Mechanical Properties

The study of enhancement of magnetorheological effect based on natural rubber/thermoplastic elastomer SEBS hybrid matrix

STUDY OF UTILIZABLE MAGNETORHEOLOGICAL ELASTOMERS

Preparation and Characterization of Magnetorheological Elastomers Based on Natural Rubber

Fabrication and Characterization of Isotropic Magnetorheological Elastomers

Preparation of isotropic MR elastomers based on silicon rubber by γ-ray radiation

High-Performance Hybrid Magnetorheological Materials: Preparation and Mechanical Properties

The Study of Magnetorheological Elastomer Based on Natural Rubber (NR)/Thermoplastic Elastomer SEBS Hybrid Matrix: Experimental and Numerical Simulation