Abstract:Statement of problem: Monolithic zirconia restorations are directly exposed to cyclic loads and temperature changes in the oral cavity after cementation. These stresses may reduce the long-term success of the material by causing uncontrolled phase transformations within the zirconia. Purpose: The purpose of this in vitro study was to evaluate the effect of mastication simulation and different measurement points on the phase transformation of posterior 3-unit monolithic zirconia partial fixed dental prostheses (FDPs) in the posterior region. Material and methods: Posterior 3-unit FDPs of monolithic yttria-stabilized tetragonal zirconia polycrystalline (Y-TZP), including BruxZir Shaded (group B), FireZr (group F), and Upcera (group U) (n=10), were machined from presintered blocks. All specimens were exposed to mastication simulation (240 000 cycles/1.7 Hz/50 N). The monoclinic phase content was evaluated by X-ray diffraction (XRD). Phase transformation was measured at the mesial connector (group M), distal connector (group D), and pontic regions (group P) before and after mastication simulation. The relative monoclinic phase amount (Xm) was calculated for all specimens. The data were analyzed by ANOVA and post hoc tests (α=.05). Results: According to XRD analysis, Xm for all groups and regions showed higher results after aging than before aging (P<.05). Group B has the lowest Xm among the groups. Group B showed a statistically significant difference compared with both group F and group U (P<.05). There was no significant difference between group F and group U (P>.05). When the regions were evaluated regardless of brand and the groups were evaluated in terms of regions, no statistically significant difference was observed between connectors and the pontic region (P>.05). Conclusions: Mastication simulation causes an increase in the Xm. However, this increase was unlikely to be clinically significant. There may be differences in phase transformation depending on the contents of the brands and sintering procedures. Variations in the phase quantity were independent of the connector regions and pontic for FDPs.

Evaluation of Phase Stability in Zirconia Femoral Heads from Different Manufacturers after in Vitro Testing or in Vivo Retrieval.

In Vitro Versus in Vivo Phase Instability of Zirconia-Toughened Alumina Femoral Heads: A Critical Comparative Assessment.

Kinetics of the Phase Transformation of Non-HIPed Zirconia Femoral Heads

Environmental Stability and Residual Stresses in Zirconia Femoral Head for Total Hip Arthroplasty: in Vitro Aging Versus Retrieval Studies

Kinetics and the role of off-stoichiometry in the environmentally driven phase transformation of commercially available zirconia femoral heads

Phase Transformation and Residual Stresses in Retrieved Zirconia Ball Implant

Nondestructive Inspection of Phase Transformation in Zirconia-Containing Hip Joints by Confocal Raman Spectroscopy

2 and 10 year retrievals of zirconia femoral heads - XRD, SEM and Raman spectroscopy studies

Surface Topology of Advanced Alumina/Zirconia Composite Femoral Head As Compared with Commercial Femoral Heads Made of Monolithic Zirconia

Role of Grain Size Fluctuations on the Environmental Resistance of Alumina-Zirconia Composite in Comparison with Commercially Available Monolithic Zirconia Femoral Head

Possible triggers for phase transformation in zirconia hip balls.

The Influence of Surface Preparation, Chewing Simulation, and Thermal Cycling on the Phase Composition of Dental Zirconia

Effect of mastication simulation on the phase transformation of posterior 3-unit monolithic zirconia fixed dental prostheses

Raman and X-ray photoelectron spectroscopic characterizations of thermal stability of 3 mol% yttria stabilized zirconia ceramics

Spatially Resolved Raman Spectroscopy for In-Depth Non-Destructive Residual Stress and Phase Transformation Assessments in 3Y-TZP Bioceramics

Phase Stability and Fracture Toughness of Zirconia Toughened Alumina for Joint Replacement

Zirconia ageing is related to total hip arthroplasty aseptic loosening. A study of 45 retrieved zirconia heads

Phase transformations in yttria-partly stabilized zirconia induced by dental polishing regimes

Phase Transformation in the Surface Region of Zirconia and Doped Zirconia Detected by UV Raman Spectroscopy

Critical evaluations on the crystallographic properties of translucent dental zirconia ceramics stabilized with 3-6 mol% yttria

Relationship Between Surface Residual Stress Fields and Hydrothermal Environment on Low Temperature Aging of 3Y-Tzp