Abstract:New heat capacity measurements, for both single phase liquid and two-phase liquid-vapor states, were carried out using an adiabatic calorimeter. A high purity sample of dimethyl ether was used for these measurements. To derive values for Cδ and pδ, the two-phase heat capacity data were treated in terms of internal energy and entropy surfaces. In this way, thermodynamically consistent values of saturated liquid heat capacity and vapor pressure were derived in a temperature range from the triple point of dimethyl ether near 132 K to the upper temperature limit of the calorimeter near 345 K. The expanded uncertainty for values of Cδ were 0.7 %, while for pδ, it ranged from 2 Pa near the triple point temperature to 50 Pa near the normal boiling temperature. The derived thermodynamic data at saturation were fitted by simple functions of temperature that cover wide ranges (150°-200°C) of temperature, which increases their utility for process design. These fitted functions were also used to make direct comparisons with the limited published data for Cδ and pδ. This is an abstract of a paper presented at the AIChE Spring National Meeting and 5th Global Congress on Process Safety (Tampa, FL 4/26-30/2009).

Thermal Conductivity of Gaseous Dimethyl Ether from (263 to 383) K

Thermal conductivity of liquid dimethyl ether from (233 to 373) K at pressures up to 30 MPa

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

Heat Capacity of Saturated and Compressed Liquid Dimethyl Ether at Temperatures from (132 to 345) K and at Pressures to 35 MPa

Vapor Pressure Measurements of Dimethyl Ether from (213 to 393) K

Thermal Conductivity of Liquid Diethylene Glycol Monomethyl Ether

Experimental Study of Pvtx Properties in the Gas Phase for Binary Mixtures of Dme and Hfc-134a

Measurement of the Thermal Conductivity of Liquid Dimethoxymethane from 240 to 362 K

Vapor Pressure Measurements of Dimethyl Ether from (233 to 399) K

Measurement of the Critical Parameters and the Saturation Densities of Dimethyl Ether

Surface Tension of Dimethyl Ether from (213 to 368) K

Thermal Conductivity of Liquid 1, 2-Dimethoxyethane from 243K to 353K at Pressures up to 30MPa

Density and viscosity measurements of diethylene glycol dimethyl ether

Thermal conductivity of liquid diethyl ether, diisopropyl ether, and di-n-butyl ether from (233 to 373) K at pressures up to 30 MPa

Gas phase PVT properties and second virial coefficients of dimethyl ether

Viscosity of Saturated Liquid Dimethyl Ether from (227 to 343) K

Thermal Conductivity of Liquid Dimethoxymethane and Dimethoxymethane + Diesel Fuel at Pressures to 30 MPa

Gaseous viscosity of dimethyl ether in the low density region

Compressed Liquid Density Measurements of Dimethyl Ether with a Vibrating Tube Densimeter

Thermodynamic Properties of Dimethyl Ether

Thermodynamic properties of saturated liquid dimethyl ether from adiabatic calorimetry