Abstract:Objectives: In the 1990s, research was conducted at General Motors R&D Center on seat safety in rear impacts. It led to the development of high retention seats and an active head restraint to improve occupant safety. This article provides an overview of the design principles found from that research and focuses on seat characteristics that lower whiplash risks. Methods: Sled and quasistatic seat testing showed how occupants interact with the seat in rear impacts and what seat characteristics improve occupant retention, energy management, and support of the head-neck, lowering injury risks. Neck displacements, moments, and forces were used to assess whiplash and more severe injury risks. A QST test was developed to quasi-statically push a dummy rearward into the seat to determine seat stiffness (k), frame strength (j), and peak bending moment (M(Hpt)). These parameters were related to neck displacements associated with whiplash. Sled tests were run with in-position and out-of-position male and female Hybrid III dummies to assess performance. A high retention seat and active head restraint were developed and put into production in 1997. Results: High retention seats have 2.3 times greater moment, develop 2.2 times greater load, but have the same stiffness as earlier yielding seats. Seat stiffness was found to be a principle characteristic related to neck displacements associated with whiplash. The combination of a stronger frame, yielding seatback, and high-forward head restraint in the high retention seat provides early head support and low neck displacements in rear impacts. Larger reductions in neck displacement were obtained by adding an active head restraint that moves the head restraint forward and upward by occupant penetration into the seatback. This substantially reduces head contact time, neck displacements, and loads. Conclusions: Whiplash risks are related to seat stiffness, the position of the head restraint, and frame strength. Low seat stiffness allows the occupant to move into the seatback without high loads on the torso until the head-neck is supported by the head restraint. A strong seat frame reduces early seatback rotation that increases the gap to the head restraint and drops it in relation to the occupant's head. A high and forward head restraint provides support of the head and neck. Large forces can be applied to the occupant once the head, neck, and torso are supported by the seat and head restraint without adverse loading of the spine. The addition of an active head restraint closes the gap behind the head before significant load develops on the neck. The movement provides a more upward trajectory of the head restraint. Low-speed rear crashes are not just a matter of whiplash; older occupants, some with cervical stenosis, are at risk for paralyzing spinal cord injury.

Research on Structural Design of Active Headrest in Rear End Collision

Concept design of an active headrest for neck injury mitigation of rear impact

Control Algorithm of Active Headrest in Rear End Collision

A Vehicle Seat Design Concept for Reducing Whiplash Injury Risk in Low-Speed Rear Impact

Combined with finite element analysis of car seat safety performance improvement

An Energy-Absorbing Sliding Seat for Reducing Neck Injury Risks in Rear Impact--analysis for Prototype Built.

Car seat design to improve rear-impact protection

Simulation Study of Effect of Seat Design Parameters on Occupant Neck Injury Potential in Low-Speed Rear Impact

Simulation and Analysis of an Automotive Active Head Restraint

Research on the Protection Strategy of Pretensioner Seat-belt with the Active Braking Technology

Design of a Head and Neck Restraint System for Use in City Cars

Study on the Influence of Seat Adjustment on Occupant Head Injury Based on Madymo

Investigation of Risk Factors Affecting Injuries in Reclining Seat under Frontal Impact

Seat design principles to reduce neck injuries in rear impacts

Effects of an integrated safety system for swivel seat arrangements in frontal crash

Research on Occupant Safety in Frontal Collision Based on Different Sitting Positions of Intelligent Vehicles

Study of AEB and active seat belt on driver injury in vehicle-vehicle frontal oblique crash

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Использование активных подголовников с целью повышения безопасности автомобильных кресел при ударе сзади в соответствии с требованиями euro NCAP

Protecting occupant in autonomous vehicle accident with rotating seat and belt airbag

Integration of Active and Passive Safety Technologies--A Method to Study and Estimate Field Capability.