Abstract:While CNTs are found to have ultra high stiffness and strength, an enormous scatter is also observed in available laboratory results. This paper studies the effects of randomly distributed Stone Wales (SW or 5 7 7 5) defects on the mechanical properties of single walled nanotubes (SWNTs) using the technique of atomistic simulation (AS). A Matern hard core random field applied on a finite cylindrical surface is used to describe the spatial distribution of the Stone Wales defects. We simulate a set of displacement controlled tensile loading up to fracture of SWNTs with (6,6) armchair and (10, 0) zigzag configurations and aspect ratio around 6. A modified Morse potential is adopted to model the interatomic forces. We found that fracture invariably initiates from a defect if one is present; for a defect-free tube the crack initiates at quite random locations. The force-displacement curve typically behaves almost linearly up to about half way, although there is no obvious yield point. Three mechanical properties - stiffness, ultimate strength and ultimate strain - are calculated from the simulated force and displacement time histories. The randomness in mechanical behavior resulting only from initial velocity distribution was found to be insignificant at room temperature. The mean values of stiffness, ultimate strength and ultimate strain of the tube decrease as the average number of defects increases although the coefficients of variation do not show such monotonic trend. The introduction of an additional defect has the most pronounced effect on the randomness in mechanical properties when the tube is originally defect free. We also found that, for a given mean number of defects in the tube, the zigzag configuration has less strength and less ultimate strain on the average, but more uncertainty in its stiffness and ultimate strain, compared with the armchair tube.

An Eshelby-type approach for defect energetics in carbon nanotubes

Atomistic Numerical Investigation of Single-crystal Copper Nanowire with Surface Defects

Molecular Dynamics Study Of Dynamic Buckling Properties Of Nanowires With Defects

Atomistic Exploration of Deformation Properties of Copper Nanowires with Pre-Existing Defects

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Numerical Exploration of Plastic Deformation Mechanisms of Copper Nanowires with Surface Defects

Bending Properties of Ag Nanowires with Pre-Existing Surface Defects

Exploration of the Defect’s Effect on the Mechanical Properties of Different Orientated Nanowires

Energetics of Stone-Wales Defects in 4 Å Carbon Nanotubes

Numerical Exploration Of The Defect'S Effect On Mechanical Properties Of Nanowires Under Torsion

Kinetics of Topological Stone-Wales Defect Formation in Single Walled Carbon

Defect Nucleation in Carbon Nanotubes under Tension and Torsion: Stone–Wales Transformation

Stone – Wales Transformation : Precursor of Fracture in Carbon Nanotubes

Formation Energies Of Topological Defects In Carbon Nanotubes

A study on the effect of defects on the buckling of double-walled carbon nanotubes under compression based on a new atomic-continuum coupling method

Influence of defect-induced deformations on electron transport in carbon nanotubes

Effect of randomly occurring Stone-Wales defects on mechanical properties of carbon nanotubes using atomistic simulation

The Controllable Mechanical Properties of Coiled Carbon Nanotubes with Stone–Wales and Vacancy Defects

Local Energy Gap in Deformed Carbon Nanotubes

Long-Range Interaction Between Stone-Wales Defects in Zigzag Single-Walled Carbon Nanotubes

Defect engineering of carbon nanotubes and its effect on mechanical properties of carbon nanotubes/polymer nanocomposites: A molecular dynamics study