Abstract:While CNTs are found to have ultra high stiffness and strength, an enormous scatter is also observed in available laboratory results. This paper studies the effects of randomly distributed Stone Wales (SW or 5 7 7 5) defects on the mechanical properties of single walled nanotubes (SWNTs) using the technique of atomistic simulation (AS). A Matern hard core random field applied on a finite cylindrical surface is used to describe the spatial distribution of the Stone Wales defects. We simulate a set of displacement controlled tensile loading up to fracture of SWNTs with (6,6) armchair and (10, 0) zigzag configurations and aspect ratio around 6. A modified Morse potential is adopted to model the interatomic forces. We found that fracture invariably initiates from a defect if one is present; for a defect-free tube the crack initiates at quite random locations. The force-displacement curve typically behaves almost linearly up to about half way, although there is no obvious yield point. Three mechanical properties - stiffness, ultimate strength and ultimate strain - are calculated from the simulated force and displacement time histories. The randomness in mechanical behavior resulting only from initial velocity distribution was found to be insignificant at room temperature. The mean values of stiffness, ultimate strength and ultimate strain of the tube decrease as the average number of defects increases although the coefficients of variation do not show such monotonic trend. The introduction of an additional defect has the most pronounced effect on the randomness in mechanical properties when the tube is originally defect free. We also found that, for a given mean number of defects in the tube, the zigzag configuration has less strength and less ultimate strain on the average, but more uncertainty in its stiffness and ultimate strain, compared with the armchair tube.

Stone – Wales Transformation : Precursor of Fracture in Carbon Nanotubes

Stone–Wales transformation in boron nitride nanotubes

Defect Nucleation in Carbon Nanotubes under Tension and Torsion: Stone–Wales Transformation

Revealing the Mechanical Bending Mechanisms of Single-Crystalline Rutile TiO2 Nanowires Near Room Temperature: Implications for Nanostructured Semiconductors

Energetics of Stone-Wales Defects in 4 Å Carbon Nanotubes

Multiscale Analysis of Fracture of Carbon Nanotubes Embedded in Composites

Fracture Nucleation in Single-Wall Carbon Nanotubes under Tension: A Continuum Analysis Incorporating Interatomic Potentials

In situ observation of intergranular fracture propagation in nanocrystalline freestanding ultrathin tungsten film

Effect of randomly occurring Stone-Wales defects on mechanical properties of carbon nanotubes using atomistic simulation

Atomistic Failure Mechanism of Single Wall Carbon Nanotubes with Small Diameters

Effects of atomic vacancy defects and their evolution mechanisms on the fracture of carbon nanotubes

Atomistic Simulations of the Nonlinear Deformation and Damage Modes of Super Carbon Nanotubes

Stress-induced Annihilation of Stone–Wales Defects in Graphene Nanoribbons

Material and Structural Instabilities of Single-Wall Carbon Nanotubes

Atomistic simulations of nanotube fracture

Atomistic-Continuum Theory of Graphene Fracture for Opening Mode Crack

Asymmetric Nanofracture in WS2 for Its Local Toughness Anisotropy

Strength and Breaking Mechanism of Multiwalled Carbon Nanotubes Under Tensile Load

Kinetics of Topological Stone-Wales Defect Formation in Single Walled Carbon

Where, and How, Does a Nanowire Break?

Deformation mechanisms of carbon nanotube fibres under tensile loading by in situ Raman spectroscopy analysis