Effects of Pre-mechanical Cycling on Plastic Deformation Resistance in a SiCp/2024Al Composite

ZHANG Fan,ZHANG Guo-ding,LI Xiao-cui,JIANG Xiao-gang

DOI: https://doi.org/10.3969/j.issn.1673-2812.2006.01.003

2006-01-01

Abstract:Effects of pre-mechanical cycling(PMC) on plastic deformation resistance of annealed and T6 treated SiCp/2024Al composites were investigated experimentally.The results show that the effects of the PMC were different for the two heat treated composites.For the annealed composite,the effect of the PMC on plastic deformation resistance was dependent to cyclic stress amplitude(σ_a ).In the case of a lower σ_a,the PMC had no effect on macroyield strength(YS) of the composite,but could raise its microyield strength(MYS) within first a few cycles.With increase in the σ_a,the YS and MYS all increased.As the σ_a was,however,over a critical value,the MYS and YS of the composite all dropped dramatically.For the T6 treated composite,the PMC was basically not beneficial to the plastic deformation resistance.