Preparation and deodorization behavior of copper-modified mesostructured MCM-41 for the treatment of malodorous gas in sewage plants
Fanzhu Meng,Fen Li,Jinguang Hu,Cailian Yu,Baocai Ge
DOI: https://doi.org/10.5004/dwt.2021.27252
IF: 1.1
2021-01-01
Desalination and Water Treatment
Abstract:To find efficient adsorption material for the treatment of malodorous gas in sewage plants, in this study, pure silicon Mobil composition of matter-41 (MCM-41) with cobblestone morphology, a member of the family of mesoporous molecular sieve, was used. Herein, copper-modified MCM-41 (Cu-MCM-41) was prepared by hydrothermal method for H2S adsorption. The experimental results showed that when the water-to-silicon ratio (nH2O:nTEOS) was 493:1, stirring time was 15 min, and modification amount of copper reached 30%; the H2S adsorption time on Cu-MCM-41 was close to 90 min and the theoretical sulfur capacity could reach 34 mg g–1, which is much higher than the adsorption performance of pure nano-copper oxide. After copper modification, the specific surface area of the sample decreased, and countless small nano CuO particles could be observed in the cobblestone particles. Moreover, these particles were found to be evenly dispersed on the surface and pores of MCM-41, which facilitated the adsorption reaction with H2S, and improved the utilization rate of the active component nano CuO. The adsorbed H2S mainly existed in the form of CuS, Cu2S, and CuSO4 on the surface of the material, and redox reaction occurred during the adsorption process. This research provides an effective approach for the preparation of new material for the treatment of sulfur-containing malodorous gas.
engineering, chemical,water resources