Abstract:For signal processing of a Micro-Electro-Mechanical System (MEMS) Inertial Measurement Unit (IMU), a digital-analog hybrid system-on-chip (SoC) with small area and low power consumption was designed and implemented in this paper. To increase the flexibility of the processing circuit, the designed SoC integrates a low-power processor and supports three startup or debugging modes for different application scenarios. An application-specific computing module and communication interface are designed in the circuit to meet the requirements of IMU signal processing. The configurable clock allows users to dynamically balance computing speed and power consumption in their applications. The chip was taped out under SMIC 180 nm CMOS technology and tested for performance. The results show that the chip's maximum running frequency is 105 MHz. The total area is 33.94 mm2. The dynamic and static power consumption are 0.65 mW/MHz and 0.30 mW/MHz, respectively. When the system clock is 25 MHz, the dynamic and static power consumption of the chip is 76 mW and 66 mW, and the dynamic and static power consumption of the FPGA level are 634 mW and 520 mW. The results verify the superiority of the application specific integrated circuit (ASIC) solution in terms of integration and low power consumption.

Design of Mini IMS Based on DSP

Design and Realization of Miniaturization Active Control System of Vibration Based on the DSP

Design and Implementation of an On-Chip Low-Power and High-Flexibility System for Data Acquisition and Processing of an Inertial Measurement Unit.

Design of Portable Ultrasonic Flowmeter Based on DSP

Design of Test System Based on DSP

Design of Micro Strapdown Inertial Navigation System Based on ARM

System of Human Motion Detection Based on DSP and MEMS

Design for Circuit of SINS/GPS Integrated Navigation System

Research of Design of Underwater Mine Fuze System Based on DSP Device

Design of Mobile Digital TV Based on TMS320DM320 Chip

The Design of GPS/DR Vehicular Integrated Navigation System Based on DSP

Application System Design for DSP Based Non-Gyros Inertial Measurement Unit Used in Shell

The design of the pint-sized star sensor based on CMOS and DSP

A Novel Single Chip Implementation of MEMS INS Data Acquisition and Processing System Using FPGA and Its Soft Processors

A Mems-Based Inertial Navigation System for Mobile Miniature Robots

MINS/GPS Tightly-Coupled Integrated Navigation System

Design of Embedded SINS Based on FPGA and DSP

Design of Navigation System Based on Dual DSP and FPGA

Design and Realization of Small Integrated Navigation System Based on High-Performance DSP

Embedded Magnetic Heading System Design And Realization Based On Dsp

Design of Signal Acquisition and Processing System Based on TMS320F2812 and LabVIEW for FAIMS