Abstract:Die attach is one of the major processes that may induce unwanted stresses and deformations into micro-electro-mechanical systems (MEMS). The thermo-elastic coupling between the die and package may affect the performance of MEMS under various temperature loads, causing unreasonable effects of the output signal, such as zero offset, temperature coefficient of offset (TCO), nonlinearity, ununiformity and hysteresis, etc. A complete characterization of these effects is critical for a more reliable design. This work presents experimental studies of the temperature effects on the dynamic properties of MEMS. Microbridges and strain gauges with different dimensions were used as test structures. They were surface-micromachined on test chips and the chips were die attached on organic laminate substrates using epoxy bonding as well as tape adhering. The material and dimension of the substrate were specially defined to amplify the magnitude of the coupled deformation for the convenience of investigation. Modal frequencies of the microbridges under a set of controlled environmental temperature before and after die attach were measured using a laser Doppler vibrometer system. The average initial residual strain was also measured from the strain gauges to help analyze the dynamic behavior. Nonlinear TCO of the frequencies were observed to be as large as 2,500–5,000 ppm for the epoxy-bonded samples, in contrast with much smaller values for the tape-adhered and unpackaged ones. The frequencies recovered to their original values beyond the curing temperature of the epoxy. A distributed feature was also observed in frequencies of the microbridges with the same length but at different locations of the chip with a maximum relative difference of 20%. The process of thermal cycling and wire bonding was also applied to the samples and caused tender shifts of the frequencies. The experiments reveal major factors that are related to the temperature effects of die attached MEMS and the results are useful for improving the reliability of a package–device co-design.

Thermally Induced Packaging Effect on the Resonant Frequencies of a Fixed-Fixed Beam

Thermal stress of MOEMS Accelerometers Based on Grating Interferometric cavity

Thermally Induced Packaging Effect of A Distributed Mems Phase Shifter

Modeling of Thermally Induced Package Effect on the Resonant Characteristics of MEMS Device

Influence of environmental temperature on the dynamic properties of a die attached MEMS device

Effect of Die-Bonding Process on MEMS Device Performance: System-Level Modeling and Experimental Verification

Effect of Die Bonding on MEMS Characteristics: Cell Library Study

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Effects of Thermally Induced Packaging Stress on a Distributed RF MEMS Phase Shifter

Design, Test and Evaluation of a Novel Die-Attach Structure for Packaging Stress Suppression of MEMS Resonant Accelerometers

Modal Characteristics of Coupled MEMS Resonator Array under the Effect of Residual Stress

Effect of Bonding on the Packaged RF MEMS Switch

Effect of Vacuum Package on the Stiction Force of Micro-structure

The Thermomechanical Coupling Effect in Multi-layered Microelectronic Packaging Structures

Modeling Of Micropitch Shift Of A Magnetoelectrical Sensor During Laser Solder Ball Bonding Process

Study of the Thermomechanical Coupling Effect in COB Packaging Structures

Study on Packaging Thermal Stress of Micromechanical Silicon Resonant Accelerometer

A System Level Modeling For Distributed Rf Mems Devices Considering Thermally Induced Packaging Effect

Modeling Of The Effect Of Process Variations On A Micromachined Doubly-Clamped Beam

The Influence of Die-Attach Adhesives on the Packaging of MEMS Accelerometer

Stiction failure of micro-structure in hermetic Packaging