Abstract:Purpose: Small calcifications are often the earliest and the main indicator of breast cancer. Dual-energy digital mammography (DEDM) has been considered as a promising technique to improve the detectability of calcifications since it can be used to suppress the contrast between adipose and glandular tissues of the breast. X-ray scatter leads to erroneous calculations of the DEDM image. Although the pinhole-array interpolation method can estimate scattered radiations, it requires extra exposures to measure the scatter and apply the correction. The purpose of this work is to design an algorithmic method for scatter correction in DEDM without extra exposures.Methods: In this paper, a scatter correction method for DEDM was developed based on the knowledge that scattered radiation has small spatial variation and that the majority of pixels in a mammogram are noncalcification pixels. The scatter fraction was estimated in the DEDM calculation and the measured scatter fraction was used to remove scatter from the image. The scatter correction method was implemented on a commercial full-field digital mammography system with breast tissue equivalent phantom and calcification phantom. The authors also implemented the pinhole-array interpolation scatter correction method on the system. Phantom results for both methods are presented and discussed. The authors compared the background DE calcification signals and the contrast-to-noise ratio (CNR) of calcifications in the three DE calcification images: image without scatter correction, image with scatter correction using pinhole-array interpolation method, and image with scatter correction using the authors' algorithmic method.Results: The authors' results show that the resultant background DE calcification signal can be reduced. The root-mean-square of background DE calcification signal of 1962 mu m with scatter-uncorrected data was reduced to 194 mu m after scatter correction using the authors' algorithmic method. The range of background DE calcification signals using scatter-uncorrected data was reduced by 58% with scatter-corrected data by algorithmic method. With the scatter-correction algorithm and denoising, the minimum visible calcification size can be reduced from 380 to 280 mu m.Conclusions: When applying the proposed algorithmic scatter correction to images, the resultant background DE calcification signals can be reduced and the CNR of calcifications can be improved. This method has similar or even better performance than pinhole-array interpolation method in scatter correction for DEDM; moreover, this method is convenient and requires no extra exposure to the patient. Although the proposed scatter correction method is effective, it is validated by a 5-cm-thick phantom with calcifications and homogeneous background. The method should be tested on structured backgrounds to more accurately gauge effectiveness. (C) 2013 American Association of Physicists in Medicine.

SU‐FF‐I‐114: Effects of Exposure Level and Anatomical Background on Detection of Simulated Microcalcifications in Digital Mammography

Visibility of Simulated Microcalcifications with an Asi/Ase Flat Panel Detector Based Cone Beam Ct System

SU‐C‐301‐05: Comparative Low‐Contrast Performance of Scan Equalization Digital Mammography (SEDM) V.s. Full‐Field Digital Mammography (FFDM): A Simulation Study with Micro‐Calcifications

Experimental validation of a three-dimensional linear system model for breast tomosynthesis.

Physics Based Contrast Marking and Inpainting Based Local Texture Comparison for Clustered Microcalcification Detection

MO-E-I-609-02: Imaging Properties of Cone Beam Breast CT- Effects of Detector Properties and Imaging Conditions

Effects of Voxel Size on Visibility of Microcalcifications in Cone Beam Breast Ct

Task-based detectability in anatomical background in digital mammography, digital breast tomosynthesis and synthetic mammography

Investigation of Exposure Factors for Various Breast Composition and Thicknesses in Digital Screening Mammography Related to Breast Dose

Improving the Quantitative Analysis of Breast Microcalcifications: A Multiscale Approach

Multichannel response analysis on 2D projection views for detection of clustered microcalcifications in digital breast tomosynthesis.

Indicator and Calibration Material for Microcalcifications in Dual-Energy Mammography

Digital Breast Tomosynthesis: Effects of Projection-View Distribution on Computer-Aided Detection of Microcalcification Clusters.

In-silico study of the impact of system design parameters on microcalcification detection in wide-angle digital breast tomosynthesis

Computer-Aided Detection of Microcalcifications Using Image Enhancement and Support Vector Classification

TH‐C‐330A‐06: Effects of KVp Setting and Radiation Dose on Calcification Visibility in Cone Beam CT

Computer-aided Detection of Microcalcifications in Digital Mammograms Using a Synthetic Technique

SU‐FF‐I‐26: Automatic Detection of Calcifications in Cone Beam Breast CT Images

Algorithmic Scatter Correction In Dual-Energy Digital Mammography

Microcalcification detection in full-field digital mammograms with PFCM clustering and weighted SVM-based method

Computer-Aided Detection Of Clustered Microcalcifications In Multiscale Bilateral Filtering Regularized Reconstructed Digital Breast Tomosynthesis Volume