Abstract:Ca1−3x/2BixCu3Ti4O12 (x=0.0–0.3) ceramics were prepared by the conventional solid-state reaction method. X-ray powder diffraction analysis confirmed the formation of cubic CCTO phase except for subtle peaks of CuO. SEM micrographs suggested that the morphologies of doped CCTO ceramics had been sheet-like for high Bi-doping amount, and the dominant grain size decreasing could be seen for the small content of Bi-doping CCTO. Dielectric properties of pure and doped CCTO were investigated in a broad temperature range of 20–420K. The results showed that bismuth doping could decrease the dielectric loss but suppress the dielectric temperature stability at the same time. Bi doped CCTO ceramics presented different relaxation properties. As to pure CCTO and BCCTO (x=0.3) only one MW relaxation (Relaxation I) could be found, which moves to higher frequency with temperature increasing. However, two relaxation processes (Relaxation I and II) appear for BCCTO (x=0.1–0.2). By means of complex impedance spectra analysis and Arrhenius fitting, we successfully separated the different conductive segments and explained the mechanisms of the two relaxation processes. Relaxation I appeared at low temperature could be attributed to the VO doping energies inside CCTO grains which did not showed significant changing of activation energy after bismuth doping. For Relaxation II at higher temperature than Relaxation I, with activation energy obviously depending on the Bi-ion concentration, may be related with the VO point defects at the grain boundaries.

Influence of Slight Bismuth Additive on the Properties of Calcium Copper Titanate Ceramic

Microstructure and Dielectric Properties of Ca1–3/2xBixCu3Ti4O12 (x = 0, 0.05, 0.10, 0.15 and 0.20) Ceramics

Electric and Dielectric Properties of Bi-doped CaCu3Ti4O12 Ceramics

Doping Effects In (Ba0.85ca0.15)(Hf0.1ti0.9)O-3 Lead-Free Piezoelectric Ceramics Prepared Via Powder Injection Moulding Using Simple Binder

Dielectric Properties of Bismuth Doped Cacu3ti4o12 Ceramics

The Study of Ca-doped BCTZ Ceramics Sintered in Reducing Atmosphere

Study of the Defect Chemistry of Ca-Doped Batio3 Ceramics

Abnormal capacitance–voltage behaviors of bismuth-doped CaCu<sub>3</sub>Ti<sub>4</sub>O<sub>12</sub> ceramics

Influence of Different Dopant Sites by Lanthanum on the Dielectric Properties of CaCu 3 Ti 4 O 12 Ceramics

Effects of Chemical Modification on the Structural and Electrical Properties of (ba0.90ca0.10)0.90(na0.5bi0.5)0.10tio3 Ceramics

Low temperature sintering and microwave dielectric properties of Bi 4B 2O 9-added 0.25CaTiO 3-0.75(Li 1/2Nd 1/2)TiO 3 ceramics

Abnormal Capacitance-Voltage Behaviors Of Bismuth-Doped Cacu3ti4o12 Ceramics

Synthesis and performance of tetragonal Ca2+ doped BaTiO3 fine powders

Effects of Ca and Mn Additions on the Microstructure and Dielectric Properties of (bi0.5na0.5)tio3 Ceramics

Effects of BaCu(B2O5) Addition on Phase Transition, Sintering Temperature and Microwave Properties of Ba4LiTa3O12 Ceramics

EFFECT OF DOPING CaO ON DIELECTRIC PROPERTIES OF BaZr0.05Ti0.95O3 CERAMICS

Structural and Dielectric Properties of Bi Doped Ba0.6Sr0.4TiO3 Ceramics

Investigation of the modulation effects of BiNbO4 doping on BaTiO3-based ceramics

Significant ion conduction in Cu acceptor-substituted bismuth titanate polycrystalline ceramics

Microstructure And Ferroelectric Properties Of Mno2-Doped Bismuth-Layer (Ca,Sr)Bi4ti4o15 Ceramics

Microstructure and Electrical Properties of LiNbO3-modified Bismuth-layer Bi4Ti3O12 Ceramics